3205Xvs0 Parts

We were concerned, to put it mildly. Our legacy washing machine, over 30 years old, had finally bitten the dust. Didn't spin, didn't agitate. The water filled up, and just sat there, getting old and gross. Now we on the hook for a new washer that we couldn't afford right now. $600-$700, plus installation. Or were we? My wife submitted our problem and details to the forums here at appliance parts pro, hoping for a reply within a few days. In less than 2 hrs (at 2 in the morning!), Jake... Read more

I replaced the hinges. The door just slides up, after opening it slightly. Each hinge is held by three screws, and has a spring hooked to the inboard end. After removing the screws, I pulled hard on the hinge, to get the spring hook exposed. The long tang, on the spring, allowed me to hook the new hinge onto the spring, before unhooking the old hinge. This is important, since losing the spring into the abyss is a pain to correct. I reinserted the hing, installed the three screws per side,... Read more

• Door won't close

My oven door hinges both broke. The metal on the frame of the oven bent and tore, eventually the hinge metal broke too since it was out of alignment. I bought two replacement hinges with good metal (remember to get one left hinge and one right hinge-the description doesn't clarify that and they look nearly identical). Since the metal on my oven frame was torn, I had to make a custom steel backing for the frame before installing these new hinges. The alignment is perfect now and the hinges... Read more

Bought one from your company. Very good service Read more

• Won't start

Tappen Gas Stove circa 1981 (uses Fridgidaire parts). Unplugged stove from 110 wall outlet. Spark control module located on back side of stove about mid-way down on left side under a black cover that juts out. Black cover had 2 phillips head screws...removed the black cover and the spark module was right there...held on by 2 additional phillips screws. Sprark module purchased was identical to old one on the stove. Removed each wire, one at a time from the old spark module (slide off) and placed... Read more

I had a friend watch the video and do the work. There was a problem in that the screws were rusted to the back plate and would not screw off. My friend had to use a drill to drill through them to be able to remove them. He had to go to a hardware store to buy a new set. Once we had the new screws it went fairly quickly. Now our oven works great just in time for baking season. Read more