Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Thrust washer for lawn tractors and garden tractors. Replaces worn, cracked, or missing washers in engine and drivetrain assemblies. Essential hardware.
Dishwasher lower door seal prevents water leaks at the door base. Replace if you notice dripping or moisture during wash cycles. Confirm fit with your model.
Thanks to Jason and his tech people at Appliance Parts Pro, I was able to remove and replace the seal and eliminate all leaks at the bottom of the door. I have a Kitchenaide (Whirlpool) dishwasher model KUDC10IXBL1. Here is how to replace the bottom door seal. 1) Shut off breaker to dishwasher on the electrical panel. 2) Open the dishwasher door completely, and while supporting the door, remove the hex head screws that hold the outside cover. 2) Close the door carefully and slip the outside... Read more
Usually ships within 4 - 14 days
Dispenser won't latch or close? This detergent dispenser releases soap at the right time. Moderate DIY repair requiring inner door panel removal.
I ordered the part, looked at a YouTube instructional video on how to do it, and did it myself. It wasn't too hard, and I have no experience. I received the part very quickly! Read more
Soap not dispensing or lid won't open during cycle? This dishwasher dispenser assembly releases detergent and rinse aid at the right time. Moderate DIY.
Replaced dispenser Read more
Dishwasher leaking from underneath? The float switch kit controls water level and stops overfilling. Typical repair time 10-30 minutes.
Removed bottom cover, located leak at float switch, removed and replaced float switch kit. The toughest part of the repair was removing the Float & Retainer Assembly (in the interior of the machine tank) which broke when I pushed it back and pulled it straight up as suggested in the service manual. The Float Switch Kit (attached to, and below the float, below and outside the tank) has a folding plastic cover which fastens with plastic clips. If you open the switch kit before removing the... Read more
Fix water leaking from under your dishwasher with this pump volute. Directs water flow and prevents leaks with integrated seal. 20-minute repair.
I reviewed the schematic and saw the Volute Seal, and Impeller Seal were the two that were closest my source of water. After watching the video about changing the Impeller/seal I removed the motor, impeller, and volute; I found that the impeller seal was the faulty one in my case. Since I'd ordered the volute and impeller seal kits (as I wasn't sure which it was) I installed both while I had it apart. Runs great, no water - simple to do. The seal changes took about 20 minutes. The only... Read more
Dishwasher stops mid-cycle or won't start? The control board regulates wash and dry cycles. A failed board causes no power or incomplete cycles.
I did a little research on the internet. I check to make sure it was getting power with Ohm meter. I took the front panel off to see what I could find. I found 2 dead roaches in the control board box and there was some brown stuff on the control board. I checked the price to replace the part online and local. AppliancePartsPros had the best price and return policy. I figured I had nothing to lose be trying the part out to see if it would work. I installed the new board and it was alive again.... Read more
Dishwasher won't start or lights flashing? The electronic control board manages cycles and timing. Moderate DIY repair restores full operation.
Replaced control board Read more
Insulation pad that fits behind dishwasher panels to restore thermal protection and reduce noise. Replace if damaged, missing, or rattling occurs.
Fix intermittent power issues or loose connections in your dishwasher. This wire connector restores secure electrical contact between components.
Fix a dishwasher motor that hums or won't start. This run capacitor provides the phase shift needed for smooth motor operation. DIY repair in 30-45 min.
Figured it was either the capacitor and/or motor. Ordered both parts to be sure. tried changing the capacitor first; same problem. Replaced the motor (leaving the new capacitor in place). Unit now works fine. Overall an easy fix once you get the washer out and tip it on its side or top to get access to the motor area. Read more
Protective cover that encloses your dishwasher's control box and internal wiring. Replace if cracked, broken, or missing to shield electronics from dust.
Secures trim and panels in dishwasher assemblies. Replace if clip is broken, missing, or worn. Prevents loose parts and rattling during operation.
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.