Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Dishwasher won't start or stops mid-cycle? A faulty door latch prevents the cycle from running. This assembly secures the door and signals control. 15-min DIY fix.
Replaced the door latch. Read more
Dishwasher overflowing or not filling properly? The water level switch controls fill amount. DIY-friendly repair, typically 20 minutes with video guide.
Replaced float switch and also replaced intake valve. Worked like a charm and the process was as easy as the YouTube video I followed made it seem. Read more
Dishwasher leaking from bottom or making grinding noise? The sump housing often cracks or wears out. Moderately difficult repair, about 45 minutes.
I noticed the floor around the dishwasher was starting to get wet and warp the wooden floor. The chopper had gotten out of line and had cut a pinhole into the sump housing and the dishwasher was leaking badly. It was quite easy to repair. Just unhook the drain hose and the wire connectors, twist off the turbidity sensor and waste motor, pull out the shims and the whole assemple comes up and out. The hardest part was pulling the motor off of the assembly, since I wasn't sure if I needed to... Read more
Fix dishwasher overflows and leaks with a new float assembly. Controls water level to prevent overfilling. Moderate DIY repair with video guide.
Removed bottom cover, located leak at float switch, removed and replaced float switch kit. The toughest part of the repair was removing the Float & Retainer Assembly (in the interior of the machine tank) which broke when I pushed it back and pulled it straight up as suggested in the service manual. The Float Switch Kit (attached to, and below the float, below and outside the tank) has a folding plastic cover which fastens with plastic clips. If you open the switch kit before removing the... Read more
Replace worn or cracked door spring bushings that secure the tension springs on your dishwasher door hinge assembly. Essential for smooth door operation.
Purchased door springs from Appliance Parts pros.com, installed them and door on our Dishwasher was back to normal, Had to pull out dishwasher from under cupboard to get to springs, as they were on the sides of the dishwasher. Read more
Standing water or dirty dishes? A clogged or damaged pump inlet screen blocks debris from the wash system. Simple DIY fix restores drainage and cleaning.
Looked at Dishwasher. Scratched head and armpit. Told wife I would fix, not repariman. Wife skeptical - shook head. Found schematic on web. Found YouTube video of guy repairing same DW model. Disassembled. Diagnosed problem. Chopper assembly welded in place by water scale -broke removing. Potty mouth. Ordered parts. Waited for parts. Washed dishes by hand. Wife doing ok. Parts arrived (in only a day or two!!! Fed Ex for 7 bucks!! Great deal). Put on nasty t-shirt, baggy shorts. ... Read more
This factory-spec screw secures panels and components in your appliance. Replacing a missing or stripped fastener restores a tight, rattle-free fit so parts stay aligned and operate as designed.
Replaced Wheel-Tub. Read more
This is a small cap that covers and seals the rinse-aid reservoir on a dishwasher door. It keeps the rinse-aid liquid contained so it dispenses at the correct time during the wash cycle to prevent water spots on dishes. Replace this cap if it is cracked, warped, or no longer seals properly, which can cause rinse-aid to leak out prematurely or result in spotty dishes.
Ordered the right one and replaced it with the new one from appliance parts pros. Read more
Fixes broken heating element brackets causing sagging or rattling noises in your dishwasher. Simple snap-on replacement restores proper element alignment.
Replaced spray arms and tube. Found all had debris in them and prohibited water pressure from reaching items. After replacement everything comes out sparkling. Don't understand how the spray arms getting plugged. Almost like waste water is recycled. Turns out to be a very easy project and if needed AppliancePartsPro has information and directions available at your finger tips.! Read more
Dishwasher not heating or drying properly? This heater probe shield protects temperature sensors and nearby components from heat damage for accurate sensing.
A bit of searching on the internet narrowed the problem down to either the heating element or the control board. As I am not much of a diagnostician I decided to replace both. Along this same line, I would never have attempted these repairs if it hadn't been for the clear, easy to understand repair videos provided for each part. Further, my decision to do my own repairs was made easier because the prices of the parts was so reasonable. I took my time, reviewed the videos and replaced the... Read more
Replacement upper spray arm for dishwashers. Installs on the top rack level to restore water distribution. Replace if cracked, clogged, or broken.
This is a 12 year old Kenmore, but my experience applies to many dishwashers. The machine had run for almost a year without being cleaned. I found parts had failed from age and water passages were jammed with hard-water deposits and pieces of food, labels, etc. that had gotten past the filters. I cleaned out what I could and replaced parts that could not be cleaned or were damaged. Dishwasher now works better than it has for years. The work, including ordering parts, took about 4 hours, but... Read more
Bottle with brush. Color: Black. Size: 0.6 fl.oz.
Replaced It With New One Read more
Size: 1/4 inch hex head, 10-12 x 1/2 inch.
This trash compactor is in our vacation home. We never use it and now we are selling the house. When I looked to replace it I was amazed at how expensive a new compactor would cost. I found the serial number on the current compact entered it and your web site came up. Your schematics were excellent and made the repair very easy! Read more
Replaces cracked, broken, or missing lower access panel on your dishwasher. Covers the base opening for a finished look and shields internal parts.
Replace your dishwasher's console door seal when you notice water leaks or gaps between the console and door. Verify fit with your model number.
Set screw secures dishwasher door handle to panel. Replace if missing, stripped, or corroded to restore tight handle mounting and prevent loosening.
Extremely easy. All the parts were included, including the necessary tool to remove the old and secure the new. Awesome!! Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.