Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
8-32 x .312 inch mounting screw for washers. Replaces lost, stripped, or damaged screws that secure panels, brackets, and components inside the unit.
Cork sealer adhesive for refrigerators and freezers. Used to seal cork gaskets and insulation joints. Replace when dried out, cracked, or missing.
Putty sealer adhesive for refrigerators and freezers. Seals joints, gaps, and connections. Replace when old sealant is cracked, dried out, or missing.
The installation of the new condenser motor was as the video described; there were no surprises. I noted the difference in operation immediately, the fan was moving at a higher rate of speed in a smoother motion. The new motor had far less shaft end play and seems to move more air across the condenser coil than the original motor. All in all, this was a relatively easy repair that solved a real refrigerator performance problem; the unit now cycles less often and generates less compressor heat. Read more
Refrigerator not cooling properly? A faulty 1/4 inch service valve can prevent proper refrigerant flow. This valve connects refrigerant lines in your system.
Ice not dispensing properly or spilling? This crusher housing secures ice-crushing components and guides crushed ice to the chute. Fixes cracked housings.
Secures wiring bundles inside your microwave. Replace this wire tie if it's cracked, broken, or missing to keep internal wires organized and secure.
Replace your beverage center's name plate if it's cracked, faded, or missing. This exterior cosmetic trim piece attaches to the front of the unit.
Mounting bracket that secures the ice maker assembly to the refrigerator wall. Replace if cracked, broken, or missing to restore proper ice maker support.
Replaced the ice maker. The kit came with everything I needed to replace the ice maker. Parts that did not come with the kit were re-used from the old one. My Whirlpool refrig/freezer is an older model so the wiring harness that came with the kit was different from my existing. So instead of disconnecting the ice maker wiring harness from the freezer, I had to disconnect the harness at the ice maker. That was a b..... Anyway after about 20 minutes, finally unhooked the connector. I had... Read more
Ice not dispensing or auger broken? This refrigerator ice crusher auger transfers ice from bucket to dispenser. Moderate DIY repair in 30 minutes.
Replaced the auger Read more
Replacement door gasket seals your refrigerator to maintain temperature and prevent air leaks. Replace when worn or cracked to restore efficiency.
Replacement mounting screw for refrigerator panels, brackets, and internal components. Replace missing or stripped screws to restore secure fit.
Replacement screw for securing refrigerator panels, brackets, and internal components. Needed when original fasteners are stripped, missing, or lost.
Replacement 8-32 machine screw for refrigerators. Secures panels, trim, and internal brackets. Needed when original fastener is stripped, lost, or damaged.
Purchased a solenoid assembly from Appliance Parts and installed it per the video on the web site. Read more
This refrigerator control panel houses the electronic controls and display. Replace if the panel is cracked, buttons are unresponsive, or display is damaged.
Replacement shelf support track for refrigerators. Guides shelves to slide smoothly in and out. Replace if cracked, broken, or worn to restore alignment.
Fix uneven cooling and warm spots in your refrigerator with this air baffle. Directs cold air properly throughout compartments. Simple DIY fix.