Fafw3801lw Parts

This is the front half of the outer tub that encloses the wash drum and holds water during the wash and rinse cycles. It forms a watertight seal with the rear tub half and includes the opening where the door boot seal attaches. Replace this assembly if the tub is cracked, leaking water onto the floor, or if the drum bearing seat is worn out and causing excessive noise during the spin cycle.

Support plate for washer components. Mounts internally to secure parts in place. Replace if cracked, bent, or broken to restore proper structural support.

Wiring harness for laundry center washer. Connects electrical components throughout the machine. Replace if wires are frayed, connectors are damaged, or broken.

Sound dampening pad for dryers. Installs inside the cabinet to reduce vibration and noise. Replace if worn, torn, or missing for quieter operation.

Mounting screw for washer cabinet and component assembly. Replace if screw is stripped, missing, or damaged during disassembly. Essential hardware piece.

Secures hoses in your laundry center. Replace if cracked, loose, or causing leaks. Confirm fit with your model number before ordering.

Spring mounting bracket for washers. Secures suspension springs to the washer tub or frame. Replace if bracket is cracked, bent, or broken from load stress.

This bushing protects the appliance service cord where it passes through the cabinet, reducing wear and preventing chafing that can expose wiring. It's a simple replacement that restores a safe cord entry point. What it does:

• Cushions and centers the service cord at the cabinet opening to prevent abrasion
• Helps keep the cord from rubbing on sharp metal edges that can cause insulation damage
• Reduces risk of shorting, sparking, or intermittent power caused by a worn cord
• Commonly replaced when the existing bushing is cracked, missing, or deformed

• One service cord bushing

• Disconnect power (unplug or switch off breaker) before servicing
• Inspect the cord and surrounding insulation; replace the cord if damage is found
• Push the bushing into the cabinet opening, then route the cord through the bushing until seated
• Reuse only if undamaged; do not force a damaged bushing into place

Secures and organizes wires inside your appliance. Replace if broken, loose, or missing to prevent wire damage. Verify fit with your model number.

Replace cracked or leaking washer fill hoses with this 5-foot inlet hose set. Includes elbows for easy installation. Restores proper connection.

Washer hose clamp secures water inlet and drain hoses to prevent leaks. Replace if loose, cracked, or causing water drips. Verify fit with your model number.

Replace your washer's cracked or broken outer door panel. This white plastic cover protects the door frame and attaches at the hinge. Restores appearance.

This control board is the appliance's primary printed circuit board. It governs cycle timing, options, and power to key components. Replacing a failed PCB can restore responsive controls and consistent operation across all cycles.

• Coordinates inputs from sensors/controls and directs outputs to motors, valves, pumps, and other loads
• Manages cycle sequencing and option selections as designed by the manufacturer
• Symptoms of a failing board can include no start/no response, cycles that won't advance or end early, intermittent/erratic operation, blank or flickering indicators, or recurring error codes

• Disconnect power before servicing; do not work on a live appliance
• Use ESD protection and handle the board by the edges to avoid damage
• Photograph existing wiring; move connectors one at a time to the matching positions on the new board
• Secure the board and any covers before restoring power; run a test cycle/diagnostic per your model's service information

Rubber grommet cushion for laundry center washers. Isolates vibration and prevents wear where components pass through openings. Replaces worn or missing.

Rubber O-ring seal prevents water leaks at hose connections and fittings. Replace when worn or cracked to restore tight seal and stop dripping. Verify fit.