Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Ice maker leaking or shutoff arm broken? This fill cup and bearing assembly directs water into the mold and supports the arm. 15-minute DIY fix.
Watched online video and worked along - it was easy and quick - I was amazed! Read more
Ice maker not filling or water dispenser not working? This water inlet valve controls flow to your refrigerator's ice and water system. DIY repair.
Order new valve Read more
The Light Bulb is an OEM part for Whirlpool refrigerators. This part illuminates the water and ice dispenser area, providing visibility and ease of use, especially in low light conditions.
Over time, the light bulb can fail due to normal wear and tear, electrical surges, or damage from vibrations and impacts.
Symptoms of a bad light bulb include:
This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.
I went on line and purchased all of the possible parts that could be worn out. I spent less than the service guy wanted to show up...The online videos were spot on. Two hours and it works like new! One of the best values on the Internet! Read more
Refrigerator not cooling or freezer making loud noise? A failed evaporator fan motor stops cold air circulation. This DIY repair takes about 30 minutes.
Removed back panel in freezer compartment. Held on by four hex head screws. Disconnected wire assembly from panel and then replaced evaporator fan motor on kitchen table. Evaporator fan motor is attached to back side of freezer panel by four hex head screws. Easy repair to do.It took me about 30 minutes to do the repair. Read more
Replacement fastener screw for appliances. Secures panels, trim, clips, and components. Needed when original screws are stripped, missing, or damaged.
Removed the handle with two screws on the inside front and pulled out the custom wood panel. Pulled the compactor out from under cabinet. Tipped it over on back of unit, supporting it with a little foot stool. Unscrewed two lower screws at bottom of unit holding black trim panel (that held wood panel in place) and lower black rubber flap. Removed two screws on lower outside side of unit that held the foot pedal. Slid off black U shaped metal frame from top of compactor towards bottom. Slid on... Read more
1/4 inch compression nut for securing plastic water lines in refrigerators and ice makers. Replace worn, cracked, or missing nuts to prevent leaks.
Ordered part from AppliancePartsPros.com and received it 2 days later. Put the part in, fit like a glove, water and ice cube maker working flawlessly again with no leaks. Thanks. Read more
Fix a refrigerator that won't cool or clicks repeatedly. This compressor start relay powers the start winding to help your compressor run. DIY repair.
After running some tests I determined that the problem was a bad defrost timer. The timer would occasionally fail to trigger the compressor to restart at the end of the defrost cycle. Since I had the unit taken apart, I replaced the termination t-stat and the compressor start relay at the same time. Parts came quick 1.5 days, job completed and the unit is up and running. Read more
Ice not dispensing or spilling in freezer? A cracked or warped ice bucket causes jams and mess. This bin stores ice and positions it for dispensing.
We found the right ice cub bin/pan, ordered it, and it arrived quickly. Fit perfectly, and it is now catching our ice. Read more
Fix freezer icing and warm fridge temps by replacing a faulty defrost timer. Typical DIY repair takes 15-30 minutes with basic tools and a multimeter.
I took the bottom tray out of the freezer and found the coils iced up severely. I was reasonably sure the defrost timer was the problem and your tech said that was a good possibility. Ordered and replaced timer. (15 minutes) Problem fixed!!! Saved purchasing a new fridge at big bucks. We live over 40 miles from a service center so the cost of having a tech come out is astronomical. Thanks!!! Read more
This factory screw secures appliance components to their mounting points. Replace missing, worn, or stripped hardware to restore a tight fit, proper alignment, and quieter operation across the affected assembly.
Ordered Bake Element, Y04100019 (Whirlpool AP4283614) to replace a broken bake element on my 30-year old Jenn-Air Model S125 Downdraft Slide-in electric range. Received the element very quickly but it had been damaged in shipping. Called AppliancePartsPros to report this and they quickly shipped another element - very easy process. To install the element, I turned off the power to the range, put on rubber gloves (just in case) and removed the two sheet metal crews at the rear of the oven -... Read more
Ice maker water line: 1/4x 8ft.
Replaced the broken parts. The water leak was caused by the drain valve not directed into drain pan Read more
Speed clip slides over panel edges to create captive threads for mounting screws. Replace worn, missing, or broken clips to restore secure attachment.
Replaced the water tube that went from the plastic tubing to the ice cube tray. Found that even though it was the same exact length as the original, there was only an extremely small gap from the end of the tube to a splash board. This may have been the root cause of my problems. Read more
Refrigerator not cooling properly? A clogged filter drier prevents proper refrigerant flow. Requires professional installation due to sealed system.
Ordered new Evaporator part and Drier from Appliance Pros. The part arrived earlier than expected and was properly packaged. I had both parts installed by a professional as they required a level of expertise above my capabilities. Works perfectly. Read more
Replaces burned-out, dim, or flickering refrigerator light bulbs to restore clear interior visibility. Easy DIY installation—just unscrew old bulb and install new one. Verify fit by your model number.
Ordered new bulb from APPros. Read more
The Shelf Retainer is an OEM part for Whirlpool refrigerators. This part holds and supports the shelves within the unit. This small but essential component ensures that shelves remain in place, preventing them from tilting or sliding out unexpectedly.
Over time, shelf retainers can wear out or break due to the constant weight of items or from accidental impact. If you notice that your refrigerator shelves are not as stable as they used to be or if they easily slide out or tilt, it may be time to replace the shelf retainer.
Symptoms of a bad shelf retainer include:
Replaced broken retainer and put the shelf back in place. Read more
Fridge clicks or hums but won't cool? A failed start relay prevents the compressor from starting. Simple DIY repair—just pull off and replace.
I replaced the Relay-Ptc and that solved the problem. I could see that there was a problem with the relay because it was arcing inside and you could see a glow coming from the inside. when I removed it from the compressor I shook it and I could hear it rattling and news for sure it was the problem Read more