Kenmore He2 Washer Front Parts

After draining the plug multiple times, I accidentally touched the water pump and it was hot. Replaced the water pump and all is good. Read more

It took two repair attempts to fix the dryer. At first, I noticed that the rear felt seal was completely worn out, so I thought that extra friction between the tub and the rear panel might be causing the motor to have to work too hard and overheat. I ordered a new seal from appliancepartspros.com, and installed it according to their instructional video, but it did not correct the problem. Then I decided that the motor must be going bad, so I watched the on-line video on how to remove the... Read more

I opened the top of the dryer (after watching the video on your website) and replaced the lever on the switch. Removed two screws near the lint filter, used a putty knife to release fasteners under the top and raised the top. Held it in place with a short piece of board then removed the two screws holding in the switch and lever. Replaced the broken lever with the new one and put it all back together. The handle was a little more difficult as it took a lot more prying with a screwdriver to... Read more

I'd replaced the motor that I purchased here about a month ago. It worked fine for a few weeks, then it just stopped and wouldn't start. I searched on the Internet and found the 3 most likely culprits. Since the dryer is 24+ years old, I decided to just purchase all 3 and replace them. The dryer cycling thermostat was different than the original, so I didn't replace it. 20 minutes and I had the dryer thermal fuse and thermostat replaced and the dryer functioning. I ordered the parts on... Read more