Kssm48qs01 Parts

Spoke with a representive that diagnosed the problem as a bad control board. After receiving the new control board, I was able to easily perform the replacement by watching the step-by-step instructional video on the website. It is now functioning normally. Read more

• Leaking

Every once in a while we'd get a small leak just under the left side (freezer door). I moved the fridge out and saw the water stain towards the front of the unit. Carefully removing the grate (see the video on how to do this so you don't snap the plastic brackets. They are part of the grate and there is one on the left and one on the right, centered from top to bottom.) Anyway the problem was visible. There is a water tube that runs into the door and presumedly up to the water dispenser. ... Read more

Replaced motor, fan and lock-nut. My repair was on a built in Refrigerator-Freezer so most of the time was spent on pulling out and putting back the unit to get to the area I needed to behind the upper top. Read more

Replaced it. Water lines are quick connect type. Putting the part back in the holding bracket was a bit challenging. Not much space to work with. Read more

First I did the obvious: Changed the evaporator fan motor and condenser fan motor. Then I realized there was too little air flow from the freezer to the refrigerator, so I replaced the air baffle assembly. Now everything works again. This should have been a piece of cake, but in the 48" Kitchenaid side-by-side built-in, the baffle assembly is mounted on the side wall of the refrigerator rather than the back wall as the video showed. That means the hole for the rear of the two screws holding... Read more

I had the water filter holder replaced to fix the problem with the water for the door and the ice maker. The holder did not come with the cover for the release button for the filter. I ordered a replacement cover (Button) for the filter release. The cover fits over the release lever and was easily snapped onto the lever. It took more time to unpack the button from the packaging then it did to install it onto the filter housing. I don't understand why this part wasn't included with the new... Read more

Ordered new part. watched repair instructions on UTube. repair went well. Struggled with the grommet that holds the wiring harness. Didn't see that another grommet comes with the switch and wiring harness. Read more

Replaced the parts for Cam Door Closer Read more

Replaced the drain pan. Read more

Purchased a new ice maker and new Emitter and Receiver boards. After replace these parts the ice maker started making ice with an hour and is continuing to make ice. Read more