Lghb2687pi7a Parts

This refrigerator door gasket creates a tight seal around the door to help keep cold air in and reduce energy loss. Replacing a worn or torn gasket restores proper door sealing and helps the refrigerator maintain temperature. What it does:

• Seals the gap between the door and cabinet to prevent cold-air leaks
• Helps reduce frost build-up and limits warm-air infiltration
• Supports consistent internal temperatures for food safety
• Can resolve symptoms like condensation on the door, visible gaps, or excessive compressor run time

• Inspect the door frame and mating surface for debris or damage before installing
• Warm the gasket slightly to make it more flexible for fitting if needed
• Press the gasket evenly into the door channel and verify full seating around the perimeter

This shelf channel is the replacement mounting rail that supports and secures a refrigerator shelf, restoring stable shelf alignment and load support. Use it when a shelf slides out of position or the mounting rail is cracked or bent. What it does:

• Provides the mounting surface and guide for a refrigerator glass or wire shelf
• Restores proper shelf alignment and prevents sagging or uneven seating
• Replaces damaged, cracked or bent shelf rails that allow shelves to shift
• Helps maintain safe storage by keeping shelves locked in place during use

• Basic hand tools required; follow the refrigerator's service diagram for exact removal and replacement steps
• Support the shelf when removing the old channel to avoid dropping or damaging the shelf
• Disconnect power (or unplug) the appliance if working near electrical components or lighting
• Replace any fasteners, clips or adjacent trim that are damaged to ensure proper fit and secure mounting

This support is the replacement mounting bracket that secures internal components in place to restore proper fit and alignment. It helps stabilize assemblies to reduce noise and prevent sagging or misalignment. What it does:

• Provides a secure mounting point for the appliance component it supports
• Restores proper alignment when original support is cracked, bent, or missing
• Reduces vibration or rattling caused by loose or unsupported parts
• Helps maintain correct spacing to prevent interference with moving parts

• Disconnect power (and water if applicable) before attempting service
• Use appropriate hand tools; avoid excessive force that can damage adjacent parts
• If fasteners are corroded or damaged, replace them with OEM-specified hardware

This connector is a factory-style wire harness connector that secures electrical wiring and provides a reliable plug-in connection for appliance circuits. It helps restore proper electrical contact and prevents loose or intermittent connections. What it does:

• Joins wiring circuits with a keyed plug to ensure correct polarity and secure connection
• Restores power or signal continuity when an original plug is cracked, corroded, or loose
• Reduces arcing and intermittent operation caused by damaged connector ends
• Fits inline with existing harness locations to maintain OEM routing and function

• One replacement connector

• Always disconnect power at the breaker or unplug the appliance before starting
• Inspect adjoining wires and terminals; trim damaged insulation and use proper crimps if required
• Push connector fully onto mating plug until it latches; secure any retaining clips or harness ties
• If you see melting, heavy corrosion, or damaged wiring, replace the harness.

This small rubber door bumper cushions and aligns the refrigerator door to reduce slamming and wear. It restores smooth closing and helps keep the door sealed for proper cooling. What it does:

• Absorbs impact when the door closes to prevent hard bangs and protect cabinet surfaces
• Keeps the door properly spaced to help maintain a consistent seal
• Reduces rattling or vibration caused by loose or worn bumpers
• Simple, low-profile part used at door contact points or stops

• One replacement bumper

• Power is off if working near electrical components; follow appliance safety precautions
• Remove the old bumper by pulling it from its mounting hole; press the new bumper firmly into place until seated
• Use gloves to protect your hands; avoid using excessive force or tools that could damage trim
• Replace with the exact OEM part number for proper fit and function