We use cookies and similar tools for site analytics and advertising. By using our site, you agree to this. See our Privacy Policy for details. Do Not Sell or Share My Personal Information
Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Silicone lubricant grease for washer bearings and seals. Replace during bearing or tub seal repairs to ensure smooth operation and prevent wear. 2 oz.
I suspected the main bearing had worn out, and I was right. It is a difficult job, because I am retired, I had the time. During disassembly, I found the hub had rusted really bad, it needed replacement. I did not buy special tools. The manufacturer repair manual says to use three OEM tools, I made some tools with wood. Simon's video is a big help. Now the washer is quiet, time will tell how good a job I did. This is the first time I opened up a washer, the second time would be much easier. Read more
Usually ships within 4 - 14 days
Restores proper tension to the idler pulley assembly for smooth drum rotation and quiet operation. Replace if worn or broken to prevent belt slippage.
The video on the site on how to replace the belt on the washer was great! The key to get the right belt is to check the model AND the MFG number. Otherwise you may get the wrong belt like I did. However, AppliancePartsPros was great and credited me for the first belt and then shipped the correct belt within 2 days. The video was great and the service was first rate! Thank you! Read more
Terminal extract tool for dryers and washers. Used to safely remove electrical terminals from connectors during repairs. Essential when replacing wiring.
Filters debris and sediment from incoming water before it reaches the inlet valve. Replace if clogged or missing to restore proper fill flow. Confirm fit.
The machine would not run a full cycle before it cut off and had the code "FE" and water was too high. The water inlet valve needed to be replaced since it was letting in too much water at time. The repair was easy. Unplug machine and turn off cold water. Remove cold water line and drain water into bucket. Remove back two braces located at the top on each end of machine This will allow you to move top cove back about one inch. Pull back top cover about 1 inch then lift off cover. Remove... Read more
This mixing valve blends hot and cold supply water to reach the selected temperature during fill. Replacing a worn valve restores correct water temperature and flow so cycles run as intended. What it does:
Replaced mixing valve. Very easy job. Read more
This spline insert is the small splined bushing that fits onto a drive shaft to transfer rotational force between the motor/shaft and the driven part. It restores a secure, slip-free connection for proper appliance operation. What it does:
Attaches directly to the motor.
My wife found soapy water on the floor of the laundry room. I removed the front access cover on the washer and found water in the bottom of the washer and seeping our the drain holes. Running a rinse and spin cycle showed water leaking out of the pump all the time there was water in the tub. I ordered this pump and after watching a youtube video of someone else doing it had no trouble installing it. Problem fixed. You do need a torx head screw driver T20 or T25 to remove the pump from the motor. Read more