Mah3000 Parts

Replaced the door assembly Before taking the door off the washer I painted the hinges with a little finger nail polish to enable the hinges to be replaced correctly. Used petroleum jelly on the outside of the vent grommet (18) so it could easily be slipped on to the door liner. Also used the petroleum jelly on the bottom of the vent tube (17) to fit into the vent grommet. Most difficult chore was rearranging the plastic lock support (3) to fit the door, the attaching the vent tube and finally... Read more

Initially replaced the pump. However, I believe the pump went bad due to the pressure switch failing and allowing the pump to run continuously. Once I replaced the pressure switch everything was fine. FYI, the wiring harness on my washer was slightly different and would not align to t the tabs on the new switch. I had to remove the black harness guide on top of the switch and just align the harness wires to the tabs manually. My ground wire was separate from the harness. I just plugged it... Read more

Just took the four screws out and installed the the new Bezel and works great! I have been putting up with this broken unit for about two years. Can't believe it so easy to fix. If I ever need a part I know now just who to call. Thank you, Steven Read more

I replaced the pressure switch & drain pump. It seems the pressure switch diaphragm was stuck to the top of the plastic housing and wouldn't move to initiate the micro switches. This caused the tub to overfill since the water supply valves did not get the message to shut off the water. The computer will eventually shut off the water when it times out, but not before a substantial amount of water gets past the door seal...Fortunately the wax motor held the door shut until I reset the timer to... Read more