Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Initially replaced the pump. However, I believe the pump went bad due to the pressure switch failing and allowing the pump to run continuously. Once I replaced the pressure switch everything was fine. FYI, the wiring harness on my washer was slightly different and would not align to t the tabs on the new switch. I had to remove the black harness guide on top of the switch and just align the harness wires to the tabs manually. My ground wire was separate from the harness. I just plugged it... Read more
Opened the washer (details later) and noted the controls and water path. Ordered dispenser bottom and cover and dispenser valve assembly and rubber washers. When the parts arrived I removed the top portion of the detergent dispenser assembly; removed the door and 2 screws from opposite door wall; snap open the front cover and lifted it off; removed 1 metal screw each from the bottom front corners of the top cover; lifted the top cover and used a piece of wood to hold it up; pull... Read more
Located in the detergent dispenser drawer, this small cup creates suction to draw liquid detergent into the wash cycle. Replace it if detergent remains in the dispenser after cycles or if dispensing becomes inconsistent.
Drain pump motor burned up, melting the electrical connector. Got a wiring harness from eBay and cut/spliced connector. Got pump from these guys and installed it. Then got "FL" error (door failed to lock). Got chassis wiring info to meter wiring harness through lock solenoid from these guys, and it checked good. Asked them to validate my troubleshooting steps, which they did. Ordered and installed the circuit board and everything works fine. Replacing the pump was about 30 minutes and... Read more
I was able to find the parts and when they arrived, the replacement took just a few minutes. Read more
With a little research - found Appliance Parts Pros and the instructional video on how to repair the flat style dryer igniter. To my surprise - the repair video showed what appeared to be my exact model or very similar to it. I ordered the igniter kit as well as the hinge hole covers (the originals had crumbled after years of being on the dryer). The parts arrived at my doorstep in a couple days. I would have been able to make the repair in about 15-30 minutes - however, I took the... Read more
This part has been discontinued and is no longer available.
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.