Mah55f6bww Parts

Watched a you tube video showing how to take machine apart. It came apart just like it was supposed to, and went back together pretty easily, too. Read more

Repair on replacing tub bearings went well . I removed front and door ,removed basket and belt pulley. used big hammer to hit the support from outer tub,cleaned and installed both bearings using a tool that I made.. Reinstalled all the parts that I removed and tested washer everything is working perfect very quite now. Read more

Replaced the door boot seal and tub seal. Watched a repair video and that made the process much easier as it described what need to be done and in what order. It was great see the very quick delivery, all parts were complete and correct. Read more

Ordered new baffle and the proper screws with help from appliance parts pros. Took washer apart. Removed soap dispenser cover, washer door, front, lifted top lid, removed seal to be able to access area to get screws in and tightened with a wrench. This part wasn't the easiest as there wasn't much room for my hand(s) to fit in, but just took my time and got it done. Read more

Busted unit open, found leaks, ordered parts. Cleaned out the mess, put new parts in, works like a champ! Easy as it can get! Read more

Ordered the part from AppliancePartsPros.com, it arrived in an undamaged box but when I opened it and took the inner panel out it was cracked and small piece was broken off. There was no packaging in the box, just the plastic panel loose in the box. I called and they replaced the part next day shipping at no additional cost to me - Thank You AppliancePartsPros.com, great customer service! The repair itself was extremely easy. removed the door from the washing machine, then removed the... Read more

Once we found the hidden 'Troubleshooting Guide' in the control panel, we were able to run a diagnostic check on it. A voltmeter was VERY helpful, and after running through the steps, found that the "inertial unbalance switch" was bad. It was easy to get to by removing the door, front panel, and then lifting the top off...it is attached to the top of the tub. One screw needed removed from the switch, and then I slid the old one off and the new on! *I must say, it took longer to figure out... Read more

Basically rebuilt the washer from the ground up. Spent more money than a new washer but we have been so happy with the way this machine has worked over the last 19 years figured it would be money well spent. Read more

Initially replaced the pump. However, I believe the pump went bad due to the pressure switch failing and allowing the pump to run continuously. Once I replaced the pressure switch everything was fine. FYI, the wiring harness on my washer was slightly different and would not align to t the tabs on the new switch. I had to remove the black harness guide on top of the switch and just align the harness wires to the tabs manually. My ground wire was separate from the harness. I just plugged it... Read more