Maytag Dg608 Parts

Ultimately is was discovered and caused by the blower wheel shaft opening was cracked and broken. Replaced blower fan wheel. Read more

Our heating element had broken coils. Typed model number in to see which parts were likely to fix the problem. AppliancePartsPros told me exactly which parts to try. For the cost, it seemed the best decision was to order the complete Heating Element Assembly, rather than risk needing the two smaller parts as well. Decided to order new vent as well. The parts arrived super fast and the on-site video showed step-by-step how to install the new part. From diagnosis to drying laundry in less than 48... Read more

Replaced the control board after removing the inner door liner, plastice board cover and board itself, by removing screws, working various plastic clips/tabs and unclipping wire harnesses from board. most of time was spent cleaning the black soot from the door, which had a terrible burnt electrical/plastic fire smell. Cleaned mold/scale off of as much of the door as I could while in there as well. Removing parts without breaking plastic tabs to hold the new parts was trickiest part. Read more

Removed rocker switch,made up jumper so the compactor could be used while awaiting replacement switch. The part came 2 days later and was installed in less tha 5 minutes. Unit working like new again. Thanks for the great service!! Read more

Replaced it with the video listed..Maytag Atlantis dryer was not heating. Checked all components inside dryer, thermostat, coils, etc. All check out ok ......last thing I checked was the terminal. It was burned out. Quick video on your website was awesome! THANK YOU for the service, and the ease of ordering parts. LOVE THIS SITE! Read more

I pulled out the old housing and unplugged the motor. It pretty much came out in pieces. Remove the plastic from the motor, then had to take a pair of vice grips to hold the spindle in place to remove the auger. Remove what was still attached to the old Housing. Cleaned everything up and put the whole unit back together. The motor looked like it was somewhat cooked but still worked, so I ordered a new motor and auger to replace it. Because this fridge is 24 yrs old, Appliancepartspros... Read more

I ohm metered the sensors to determine which one was bad (open) Looked up the part on the parts drawing. Ordered part and had the dryer running 2 days later Read more

Weekend laundry became very noisy, our 1987 Whirlpool washer began doing a dance across the floor and the drum was banging into the inner cabinet. After doing some research and watching a few videos on Appliance parts pros website. I inspected the washer and noticed one leg the rubber coating disintegrated, decided to change all four legs, springs and lid switch. Hardest part of the job is getting the cabinet together. Ops check good. Read more

I simply removed and replaced the bake element and light bulb. The only difficulty I had was working around the open oven door. I relied on the Appliance Parts Pros videos for procedures on how to do this safely and correctly. I would not have attempted this repair without the videos. The only problem I had was the $5 screws ($10 for the two I purchased) were not the same type as the original scews and they did not "grip" the oven wall properly so I had to re-use the original screws which were... Read more

Replaced it with the video listed..Maytag Atlantis dryer was not heating. Checked all components inside dryer, thermostat, coils, etc. All check out ok ......last thing I checked was the terminal. It was burned out. Quick video on your website was awesome! THANK YOU for the service, and the ease of ordering parts. LOVE THIS SITE! Read more

Took off the old parts and replaced with the new parts Read more