Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Replacement fastener screw for appliances. Secures panels, trim, clips, and components. Needed when original screws are stripped, missing, or damaged.
Removed the handle with two screws on the inside front and pulled out the custom wood panel. Pulled the compactor out from under cabinet. Tipped it over on back of unit, supporting it with a little foot stool. Unscrewed two lower screws at bottom of unit holding black trim panel (that held wood panel in place) and lower black rubber flap. Removed two screws on lower outside side of unit that held the foot pedal. Slid off black U shaped metal frame from top of compactor towards bottom. Slid on... Read more
1/4 inch compression nut for securing plastic water lines in refrigerators and ice makers. Replace worn, cracked, or missing nuts to prevent leaks.
Ordered part from AppliancePartsPros.com and received it 2 days later. Put the part in, fit like a glove, water and ice cube maker working flawlessly again with no leaks. Thanks. Read more
This factory screw secures appliance components to their mounting points. Replace missing, worn, or stripped hardware to restore a tight fit, proper alignment, and quieter operation across the affected assembly.
Ordered Bake Element, Y04100019 (Whirlpool AP4283614) to replace a broken bake element on my 30-year old Jenn-Air Model S125 Downdraft Slide-in electric range. Received the element very quickly but it had been damaged in shipping. Called AppliancePartsPros to report this and they quickly shipped another element - very easy process. To install the element, I turned off the power to the range, put on rubber gloves (just in case) and removed the two sheet metal crews at the rear of the oven -... Read more
Internal tubing that carries water from the supply valve to various refrigerator components like ice makers and dispensers. Replace if you notice water leaks inside the refrigerator or reduced water flow to dispensers.
Replaced the broken parts. The water leak was caused by the drain valve not directed into drain pan Read more
Fix ice maker overfilling, water leaks, or no water dispensing. This refrigerator water inlet valve kit replaces older Y-type valves. Video guide included.
I replaced the dual outlet valve which did not fix it then i replaced the inlet valve which fixed it Read more
The Screw is an OEM part for Whirlpool refrigerators. This screw secures the refrigerator door hinge in place, allowing the door operates smoothly and seals properly.
Over time, screws can become loose or go missing during repairs or adjustments, which can lead to a misaligned door, compromised sealing, and increased energy consumption.
Symptoms of a bad screw include:
This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.
As soon as the parts arrived, installed them seamlessly. Thank you. Read more
Size: 1/4 inch hex head, 10-12 x 1/2 inch.
This trash compactor is in our vacation home. We never use it and now we are selling the house. When I looked to replace it I was amazed at how expensive a new compactor would cost. I found the serial number on the current compact entered it and your web site came up. Your schematics were excellent and made the repair very easy! Read more
Refrigerator not cooling properly? A clogged filter drier prevents proper refrigerant flow. Requires professional installation due to sealed system.
Ordered new Evaporator part and Drier from Appliance Pros. The part arrived earlier than expected and was properly packaged. I had both parts installed by a professional as they required a level of expertise above my capabilities. Works perfectly. Read more
Protective seal grommet for hoses, tubes, or wires passing through refrigerator cabinet. Replaces cracked, worn, or missing grommets to prevent leaks.
Replaces burned-out, dim, or flickering refrigerator light bulbs to restore clear interior visibility. Easy DIY installation—just unscrew old bulb and install new one. Verify fit by your model number.
I'm way too lazy to go to a store and look at a gigantic wall of light bulbs. So I poured a glass of wine, googled the make and model of my refrigerator followed by "lightbulb" and this bulb came up. If you're tracking the full length of this project you'll be interested to note that I held up the bulb for roughly 3 seconds to conclude it was the right one. *don't drink too much wine before this part. I counted the bulbs in my fridge/freezer (also do this before too much wine) and decided I... Read more
Fridge not cooling or running constantly? A faulty defrost timer causes frost buildup and temperature swings. Most DIYers replace it in 15 minutes.
At first, I suspected the evaporator fan motor was going bad, but when I went in to check it out, I found the evaporator coils totally frozen up; the fan was cavitating. I defrosted the coils completely and checked everything out. By process of elimination the Defrost timer had to be the culprit. I unplugged the timer and sure enough, the motor winding was open. Replacing the defrost timer fixed my problem. Troubleshooting (using the information available on your web site) took a little... Read more
Refrigerator making clicking sounds and not cooling? This overload relay kit fixes compressor start problems. Easy DIY repair—pull off old relay and install.
I was able to pull off the old relay and swap out with the new relay. Everything went together perfectly. Read more
Fixes clicking noise from compressor and fridge not cooling. Includes relay, overload protector, and capacitor. Most DIYers complete in 20-30 minutes.
Thawed out the evap/heat exchanger assembly, replaced the overload/relay kit as well as the defrost control board and the fridge was back in business, everything working fine. I'm kicking myself for not ordering these parts earlier. there was a clicking sound coming from the compressor that I ignored which was a huge mistake. Read more
Fixes ice dispenser not dispensing or auger not turning. This motor assembly drives the auger shaft that moves ice from bin to chute. Moderate difficulty.
Replaced the motor, however not the easiest to do with the older refrigerators. First I had to remove the shelf that hold the ice bin. There is a small screw midway underneath the tray. Once removed the shelf is loose but still hard to remove. There is a side panel that is slotted andonce removed the shelf can then be removed, but not knowing that it is a very odd fitting unit. Then comes the unplugging which cannot be seen so it is all by feel. Once the shelf drops down the plug is now... Read more
Mounts in the dispenser to secure the ice housing assembly. Keeps the chute and door aligned for smooth dispensing. Replace if cracked, broken, or worn.
Replaced the ice tray and motor mount plate. While I was there I replaced the thermostat also. New parts arrived in a day and a half. Read more
Ice stripper removes ice cubes from the ice maker mold so the dispenser or storage bin fills properly. Replacing a worn or broken stripper helps the ice maker eject cubes cleanly and reduces ice jams or stuck cubes. What it does:
Checked out the video on your site on how to disassemble the ice maker. Was really easy when you know the correct sequence. Only 3 screws and it's out of the freezer. Disassembled the ice maker on my kitchen counter and replaced the ice stripper. Reassembled and installed back in my freezer. It is as good as new Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.