Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Fix ice buildup in freezer and warm fridge temps. This defrost thermostat monitors evaporator temperature to control defrost cycles. DIY-friendly repair.
After watching numerous videos I was able to discern that the problem was with one of the following: the timer, the heater, or the thermostat. a short time check showed me that the timer was working so that narrowed it down to the other two. Not having the necessary tools to check those two I ordered both parts. Once the parts came and I took out the old parts it was quite evident that it was the heater since it had black burn marks on it. I decided to install the thermostat also since it... Read more
Water pooling under your fridge? A cracked evaporator drip pan lets defrost water leak onto your floor. This pan collects meltwater and lets it evaporate safely.
Evaporator pan was cracked and needed replaced. It took longer to pull the fridge away from the wall than to actually replace the pan. Pulled the old one out and slid the new one in place. Replaced the cover on the back and was finished. Read more
Seals the fresh food door to keep cold air in and prevent condensation. Replace when torn, deformed, or no longer sealing evenly. Confirm fit by model.
Ordered gasket and viewed video. My door was different and had screws holding inner door panel (just the plastic shelves). I easily removed the screws, the old gasket was easily removed, and the new one inserted without needing to perform any cutting or putty knife as shown on video. Read more
Seals freezer door to prevent warm air leaks and frost buildup. Replace when worn, cracked, or not sealing properly. Confirm fit with your model number.
I ordered a new gasket and my husband and I installed it. Read more
Drawer roller enables smooth gliding of refrigerator drawers. Replace if drawer falls off track, sticks, or roller is cracked. Verify fit with your model.
Popping the old draw glides off was the toughest part of the job, ad even that was fairly easy, once I noticed the little retaining tabs near the front of the drawer. Pushed in on the tabs, while pushing back on the drawer glide rail and it popped right off. One minor problem I did note: When the rollers were installed on the shoulder screws, they would not turn. One roller just had a burr around the inside edge of the hole. The other the entire bore was a bit undersized, creating a snug fit.... Read more
Replace a cracked, yellowed, or missing fresh food door handle on your refrigerator. This white handle installs on the main compartment door for secure grip.
I took out the old screws which were a bit of a challenge. The new handles seemed too short. Learned they needed to be warmed to be more flexible. Put near fireplace for a few minutes. Then with a little pressure they snapped into place and I screwed them in. Looks like new again. Read more
Secures covers, brackets, and internal panels in your refrigerator. Replace missing, stripped, or corroded screws to restore tight mounting.
I ordered the part from you which arrived much sooner than expected. I replaced the Rail-Mulln. It was so easy to fix, next time I'll let my wife do it. Read more
Refrigerator not cooling or compressor won't start? This overload protector prevents motor damage from overheating. DIY-friendly fix in under 30 minutes.
Used a muiltimeter to test all parts and ohm'ed out all parts. found out condenser fan motor seized up [open winding in motor] replaced that, and found that also caused the compressor overload and relay to fail, from over heating and over cycling, replaced both parts, powered up the refrigerator retested all electrical parts checked amp reading on all parts under load conditions,works good know, hope to get another 15 years out of this refrigator, its a maytag. over 20 years old. Read more
Center hinge spacer maintains proper door alignment and spacing. Replace if your refrigerator door sags or seal fails. Confirm fit with your model.
Lower hinge pin serves as the pivot shaft for your refrigerator door. Replace this part if worn, bent, broken, or missing to restore smooth door movement.
Temporarily stuck a BMW lug bolt through the bracket and pivot opening to secure the door on the base, then waited just 3 days for the exact parts to come in from AppliancePros. Searching for the appliance model number brought me to the Appliance Pros website where finding the exact parts was quick and easy. Getting the correct part installed was a bit more involved as I had to remove and reinstall the bracket once the hinge pivot was installed, but it was quick and easy with my son holding the... Read more
Replaces a worn or heat-damaged refrigerator light socket to restore interior lighting. Install when bulbs won't light despite replacement. Confirm fit by model number.
I bought a new bulb but it did not work. Then the super looked at it and realized the socket was not good. Read more
Protective seal grommet for hoses, tubes, or wires passing through refrigerator cabinet. Replaces cracked, worn, or missing grommets to prevent leaks.
Refrigerator making clicking sounds and not cooling? This overload relay kit fixes compressor start problems. Easy DIY repair—pull off old relay and install.
I was able to pull off the old relay and swap out with the new relay. Everything went together perfectly. Read more
White refrigerator door handle for the fresh food compartment. Replaces cracked, broken, discolored, or missing handles to restore a secure grip.
Replaced handle Read more
Loose panels or rattling components? This mounting screw secures body panels and electronics in appliances. Quick 5-minute fix for most models.
VERY EASY TO REPLACED OLD COVER-UNIT NEW COVER-UNIT. Read more
Replacement mounting screw for refrigerator panels, brackets, and trim. Restores secure fit when original screw is stripped, missing, or damaged.
REPLACED THE 4 BRACKETS FROM BOTH THE REFRIGERATOR AND FREEZER DOOR(S) HANDLES. Read more