Sca2000 Parts

I used long needle nose pliers to pull out the remaining flexible switch cover. `````````````````I then used a screwdriver to push the replacement cover into hole to cover push button. Repair completed. Read more

My husband is the hero in this story. At this time in our lives we weren't looking to purchase another microwave. After 10 years at my company, due to a workforce reduction, my position was eliminated. He quickly realized it could be the fuse. We searched the microwave and the part on line and appliance part pros came up with the parts for our microwave. We needed the fuse and the fuse holder. For under $20 we were able to get the microwave working again. Thank you appliance part pros for... Read more

If you search for this issue online, you’ll see this is caused by a faulty door switch - the primary interlock micro switch (with the red button). This switch is at the lowest position in the bracket that holds the switches. The hardest part for me was pulling the cover off. Two screws on one side of the black cover, one on the other side and several screws in back. The cover slides back. The switches are clearly visible on the right hand side. The white door paddle presses on the switch... Read more

Replaced Read more

CALLED APPLIANCE PROS,DESCRIBED THE PROBLEM AND THEY IDENTIFIED THE HEATING THERMAL FUSE AS WELL AS ANOTHER POSSIBLE FUSE.THEY TOLD ME WHERE IT WAS LOCATED IN THE MICRO HOUSING COMPARTMENT AS WELL.RECEIVED IT ON A FRIDAY AND CALLED ON A SATURDAY JUST TO BE SURE I DID NOT SWAP OUT THE WRONG ONE.A WOMEN ASSISTED ME THAT KNEW EXACTLY WHAT SHE WAS TALKING ABOUT.ITS A NEW WORLD WITH THE INTERNET AND THIS EXPERIENCE WAS A GREAT ONE. THANKS APPLIANCEPARTSPROS GLENN FROM LONG ISLAND NEW YORK Read more

14 year old GE Profile microwave wouldn't heat, but had power. Read reviews here. Ordered triumvirate of magnetron, capacitor, & diode. Was hoping not to need the capacitor as this was an expensive part; and if not needed to return to AppliancePartsPros, which has been SOP. After watching a couple YouTube videos of microwave capacitors being shorted, I made a capacitor discharge tool ordering 24W 100K Ohm resistor and high voltage test wires w/ alligator clips from amazon. At the same time,... Read more

Problem was the primary interlock switch. The switch checked OK for continuity but when installed and activated by the door closing, the switch would not close due to the over travel in the switch caused by the door lever. That would have been easy and inexpensive, however when attempting to disconnect RY2 while troubleshooting the top of the relay came out which was impossible to reassemble. That mistake cost me a new main board ($180). SO, if you disconnect the relay hold the top in place... Read more