Wtw8900bco Parts

APPLIANCE PARTS PROS HELPED ME AND GUIDED ME FOR THE PARTS. PROBLEM FIXED. Read more

Once you tilt the washer and prop it against something it's a pretty straight forward and easy fix. If you watch the instructional "How-to" video beforehand, the repair should take between 30 to 60 minutes. It all depends on your skill level and if everything goes smoothly. Make sure you have all the proper tools, grease and blue thread lock at the ready to help you move this repair along faster. This repair was in conjunction with replacing the motor position sensor. I didn't know I needed a... Read more

Replaced the drain pump and the drain hose (since I was replacing the drain pump). The new drain pump seems to pump out the water more forcefully than the one replaced. Have not received a LD code during the wash cycle since the replacement was installed. Read more

Motor control board was flashing 4 times, indicating that the mode shifter had an error. I disconnected the mode shifter's wire from the controller and measured the resistance between the 2 leads with an ohmmeter. Since the reading was infinite, that meant that the mode shifter coil or in-line thermal sensor was electrically open, i.e. bad. As this fix is near a complete tear-down of the washing machine, here are a few tips I discovered. 1) the hub nut is difficult to remove and you need a... Read more

APPLIANCE PARTS PROS HELPED ME AND GUIDED ME FOR THE PARTS. PROBLEM FIXED. Read more

I put all pieces that I ordered on the dryer and plugged it in. Read more

I ordered two replacement baffles and screws, then lifted the top of the dryer to access the drum and installed the two new baffles. Read more

Replaced rotor and stator Read more

Attached drain hose extension and it more than reached the drain. Read more

Ordered the shaft, bearing, seal kit. I didn’t order the tool to press the bearings in. If you’re not experienced in changing bearings, I suggest you order it. Straight forward repair. The top of my Whirlpool Cabrio comes off differently than the video showed, everything else was spot on. The adhesive is tacky...wear surgical gloves, trust me. One more thing, get a 1-1/4 “ short box wrench for taking off the shaft bit. Read more

I listen very carefully and looked up on line many items that may cause it. One thing, along with the knock was a ting like noise. Like tapping on the sheet metal of the machine. I rocked the drum back and forth and could only find a similar nose. Rotating had nothing. At that point I figured it had to do something with the suspension rods. The rod toward the back right side would ever so slightly stick (ball) when rocking the tub then the ball would have a chatter like movement. I lubed up... Read more

This trash compactor is in our vacation home. We never use it and now we are selling the house. When I looked to replace it I was amazed at how expensive a new compactor would cost. I found the serial number on the current compact entered it and your web site came up. Your schematics were excellent and made the repair very easy! Read more

I replaced a broken part which attaches the hinge to the lid spring assembly and replaced both hinges which were twisted/bent. The springs themselves were ok but a part in the assembly had broken so one spring was shouldering the entire weight of the lid and the hinges had twisted. This machine is not that old and it seems as though the glass lid is a little too heavy for the hinges. I was very impressed with how easy it was to locate the replacement parts online and how fast they showed up. Read more

Replace faucet adapter, replace fill and drain hose assembly. You must remove outer cabinet to be able to route new hoses and access hose connections under tub. Read more

Followed the Appliance Parts Pros YouTube video. No room was left for error. Read more