Assy-Case Sensor Parts

When I pulled out the dryer from the wall, I could see dust/lint had accumulated everywhere and the vent system was compromised. I vacuumed up the dust/lint accumulation outside and then inside the vent system. I then opened the lower cabinet to clean and check its condition. I removed the water steamer bottle and its sub-assembly and then the drum. After cleaning and inspecting components — both visually and with a multi-meter I determined the problem was the appliance doing what it was... Read more

I have order three parts, guide filter, cover guide, and sensor assembly. My previous cover guide was from two parts, when sensor assembly was one of them. New part ( guide cover ) was all in one piece so I just transfer old metal part of sensor to new cover guide and I don't need that sensor assembly anymore. I have ordered all three parts overnight by Fedex, ordered 15 min before 5pm, so next day it was here. Dryer is fixed, I'm happy. Read more

• Won't start

I have a Jenn-Air microwave that didn't turn on and had no lights. It just stopped working completely. I unplugged the unit and had to remove the rear cover using a *security screw kit* that prevents people from opening the rear panel. Once opened, I removed the fuse and testing it with an OHM reader to determine that the fuse went bad. But I also had to determine why the fuse blew and noticed a sticky oily substance under the Capacitor. I used a rubber glove and needle nose pliers to... Read more

• Too hot

Cleaned exhaust duct, but only from the dryer/laundry room side. Replaced thermal fuse. Unit worked for about two loads and thermal fuse blew again. This time I cleaned the exhaust vent on the roof of my 2-story house. It was found to be partially obstructed and I was able to remove a significant amount of lint from it. Also, I researched the problem and followed someone's advice to replace the cycling thermostat together with the thermal fuse if the thermal fuse blows. So far it has been... Read more

Took everything out and transferred it to coolers etc. Unscrewed and took freezer unit apart ..Evaporator fan not working and made decision to replace motor and bi metal defrost thermostat. Order parts from Appliance Pros. com and the unit was put back together and so far it corrected the problem. The instructions and service were outstanding. Great Company. Read more

Replaced thermostat and heater. Read more

Great place to buy parts I can't say more than that Read more

• Takes too long to dry

Replaced timer and cycling thermostat. cycling thermostat was the problem. For some reason it wasn't getting the message to the timer needed to cycle the dial. Read more

The defrost heater element looked good and had continuity. The defrost thermostats checked good, so that just left the Defrost Module as the likely suspect. I installed a new defrost control module and thermostats. The thermostats were inexpensive and the old ones could have been intermittent, The only "tricky" part was finding out how to get to the back screw that holds the main control panel. Discovered that the return air duct surrounding the control panel needed to come off. It helps... Read more

• Freezer not defrosting
• Freezer section too warm
• Fridge too warm

Ordered a ge thermostat part . Took everything out of freezer , unscrewed panel and took the plate out. Used a hair dryer to defrost ice. Took out old part and installed new part. Everything is working just fine!!! Used a meter to test old/bad part and indeed it was dead. Read more

Replaced the bake element. The manufacturer did not leave enough wire to pull the connections into the oven so I had to open the back and locate the connections. Read more

Purchased a new sensor from AppliancePartsPros.com. Installed new part - Problem fixed. Read more

• Too hot

I replaced the main parts for the dryer cycle system Read more