Hardware Hand Small Engine Start Switch Parts
Genuine Ge part
By: Ge
Part Number: WB1M1
ST10-16 X 7/16"
Do-It-Yourself Stories from Customers like You
Bottom heating element not working on a ge electric range David K. • Portsmouth , RI • December 21, 2014
Move stove to unplug, remove rear center panel, indentify the two spade connectors that feed the heating element and remove (unplug) them. Remove two screws that hold the element to the inside rear wall of the stove and remove element. Install new element, plug in the previously removed spade connectors, re-install rear center panel, plug range (power) in, move stove back into place and enjoy.
Read more
More
$9.48
- Compare At:
-
$10.43
- You Save:
-
$0.95
Genuine Bosch part
By: Bosch
Part Number: 00611312
This switch is mounted on the dishwasher frame and detects when the door is properly closed to allow the wash cycle to begin. Replace it if your dishwasher won't start even with the door firmly closed, or if it stops mid-cycle unexpectedly.
Do-It-Yourself Stories from Customers like You
Dishwasher would not start. Jason M. • Florence , SC • November 30, 2020
REPLACED DOOR LATCH AND DOOR LATCH ASSEMBLY. EVERYTHING WORKS AGAIN.
Read more
More
$37.95
- Compare At:
-
$44.78
- You Save:
-
$6.83
Genuine Speed Queen part
By: Speed Queen
Part Number: 202937
If your washer overfills, underfills, or won't advance cycles, the water level pressure switch may have failed. Takes about 10-15 minutes to replace.
Do-It-Yourself Stories from Customers like You
Broken pressure switch Carole Y. • Yakima , WA • November 06, 2019
Bought part from you and got a repairman to put it in. Darlene of your staff found part I needed. Nice lady! Repairman charged $82 to do a 10 minute job. Not your fault!
Read more
More
$123.78
- Compare At:
-
$148.54
- You Save:
-
$24.76
Genuine Frigidaire part
By: Frigidaire
Part Number: 318191000
Burner won't heat, stuck on high, or works intermittently? This cooktop burner control switch restores reliable on/off control. Easy DIY repair.
Do-It-Yourself Stories from Customers like You
I am buying a few new replacement parts for my frigidaire 40' range before the need arises they no longer make that size and i had my kitchen changed to fit this range e just iare William M. • Fishers , IN • January 23, 2016
I worked with Bud and he was most helpful. I was very happy with the service that was offered. I liked the quick shipment, good packing and only paying ONE time for shipping.
I would recommend your company again and would ask to deal with Bud again.
Thanks for you service.
Read more
More
$82.46
- Compare At:
-
$103.97
- You Save:
-
$21.51
Genuine Samsung part
By: Samsung
Part Number: DA34-00006C
The Refrigerator Door Switch ensures your Samsung refrigerator operates smoothly by accurately detecting when the door is opened or closed. This genuine OEM part is specifically designed for Samsung refrigerator models, providing a reliable and secure fit. With the door switch functioning correctly, your refrigerator maintains optimal cooling and energy efficiency, preventing issues such as improper temperature control or excessive energy usage. Installing this switch is straightforward, allowing you to quickly restore your applianceGÇÖs functionality without hassle. By choosing this genuine OEM part, you benefit from guaranteed quality and compatibility, ensuring your refrigerator continues to keep your food fresh and organized. Enhance your refrigeratorGÇÖs performance and extend its lifespan with the dependable Refrigerator Door Switch .
This part fixes the following symptoms
-
Ice maker not making ice
-
Not dispensing water
-
Light not working
See more...
Do-It-Yourself Stories from Customers like You
Samsung refrigerator rb2055sl door alarm beeping continuosly light out and temperature would jump from 34 degrees to 67 degrees Helen L. • Miami , FL • December 05, 2015
Ordered the Door Switch. Arrived the next day. It took less than 5 minutes to install the new switch. The beeping stopped immediately, light worked and temperature gauge showed 34 degrees.
Read more
More
$46.26
- Compare At:
-
$54.59
- You Save:
-
$8.33
Genuine Samsung part
By: Samsung
Part Number: DE92-90508A
Secures microwave to mounting bracket. Replaces stripped, cross-threaded, or missing cage nuts. Installs inside cabinet housing for stable installation.
Do-It-Yourself Stories from Customers like You
Removed 1 year old microwave to paint kitchen internal thread assembly stripped Joel L. • North Richland Hills , TX • December 01, 2016
I took the machine screws out of the outer panel for the right side only. Then pull the panel back a bit to release the lips from the front of the machine and had immediate access to the internal assembly that housed mounting nut.
Order the new parts from AppliancePartsPro.com during the Thanksgiving week. Still received via FedEx in short time due to their same day shipping - which was greatly appreciated and surprising. Most small part places take a while to get the product out the door,...
Read more
More
$20.39
- Compare At:
-
$24.26
- You Save:
-
$3.87
Genuine Ge part
By: Ge
Part Number: WB24T10147
This is a high-amp SPDT (single pole, double throw) switch used in the oven door mechanism. It detects whether the oven door is open or closed and signals the control to enable or disable certain functions such as the oven light or broil element. Replace this switch if the oven light does not turn on or off when the door is opened or closed, or if the oven does not operate correctly in relation to door position.
Do-It-Yourself Stories from Customers like You
Faulty self cleaning latch Gregory K. • Bel Air , MD • December 28, 2016
Replaced faulty latch with new latch. New latch was different configuration, but the fit was okay. The only issue was that the wires to the electric motor were just barely long enough.
Overall easy repair if you have a T15 Torx bit, phillips screwdriver, and 1/4" nut driver. Hardest part is removing the gas cooktop to gain access to the cleaning latch. 0. Turn off electric to stove; remove the cast iron grates, center caps/orifices, and catch pans from the stovetop. 1. Disconnect the...
Read more
More
$23.34
- Compare At:
-
$27.54
- You Save:
-
$4.20
Genuine Whirlpool part
By: Whirlpool
Part Number: WP22002162
Washer won't spin or door won't lock? This door lock spin enable switch signals the control to start high-speed spin. Moderate DIY repair, 30-60 minutes.
Do-It-Yourself Stories from Customers like You
Washer would not spin in high speed at end of wash Joe Ray S. • Albuquerque , NM • January 19, 2015
Replaced the motor wax door lock switch and the door lock spin enable switch.
Read more
More
$40.41
- Compare At:
-
$48.49
- You Save:
-
$8.08
Genuine Whirlpool part
By: Whirlpool
Part Number: WP12575501
This limit switch monitors a set condition and opens or closes its contacts when that limit is reached. Replacing a failed switch restores proper safety cutoff and consistent operation of the appliance's heating or movement system. What it does:
- Senses a limit condition at its mounting point (such as temperature or travel/position, depending on model)
- Changes state at a defined threshold to protect components and wiring
- Interrupts power to heat or motor circuits, or signals a control to respond
- Common failure signs: no heat or shuts down early, runs continuously, won't start, or intermittent operation
What's included:
Install notes:
- Disconnect power to the appliance before servicing
- Note wire positions; transfer connectors one at a time or take a photo for reference
- Reinstall in the original orientation so the actuator or sensing surface contacts the correct area
- Address root causes (blocked airflow, binding mechanisms, shorted components) to prevent repeat failures
Do-It-Yourself Stories from Customers like You
Water dispenser quit working Frank K. • Pass Christian , MS • February 20, 2017
I replaced the switch which was bad and also replaced the water inlet valve.
Read more
More
$49.51
- Compare At:
-
$59.41
- You Save:
-
$9.90
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8268909
Dishwasher overflowing or not filling properly? The water level switch controls fill amount. DIY-friendly repair, typically 20 minutes with video guide.
Do-It-Yourself Stories from Customers like You
Washer would not fill with water Ty J. • Hillsboro , OR • July 08, 2018
Replaced float switch and also replaced intake valve. Worked like a charm and the process was as easy as the YouTube video I followed made it seem.
Read more
More
$50.57
- Compare At:
-
$60.18
- You Save:
-
$9.61
Genuine Frigidaire part
By: Frigidaire
Part Number: 134716700
Washer that fits between the support roller and shaft in your dryer. Replace if worn, cracked, or missing to maintain proper drum alignment and support.
More
$1.36
- Compare At:
-
$1.50
- You Save:
-
$0.14
Genuine Whirlpool part
By: Whirlpool
Part Number: 9871829
Fix a compactor that won't start, stops mid-cycle, or requires holding the pedal down. This drawer tilt switch is a quick 15-second replacement.
Do-It-Yourself Stories from Customers like You
Compactor would start sometimes by just closing the door when you start it by normally lifting the pedal it would not stop at the end of it's cycle Bruce H. • Hewitt , NJ • January 19, 2015
I replaced the upper switch that contacts the door in a closed position and more important the start switch contacted by lifting the start pedal.
Read more
More
$50.57
- Compare At:
-
$60.68
- You Save:
-
$10.11
Genuine Lg part
By: Lg
Part Number: EBF60662911
This is a spark ignition switch assembly with wiring harness that controls the electric igniters on a gas range cooktop. It sends voltage to the spark modules when a burner knob is turned, initiating the clicking ignition sequence. Replace this part if your burners won't spark when turned on, spark continuously even when knobs are in the off position, or if only some burners ignite properly.
This part fixes the following symptoms
-
Doesn't shut off
-
Gas igniter glows, but will not light
See more...
Do-It-Yourself Stories from Customers like You
All the igniters spontaneously began to fire Michael S. • Adams , NY • October 12, 2019
Found a YouTube video online that provided instruction on how to change out the part.
Read more
More
$74.95
- Compare At:
-
$89.19
- You Save:
-
$14.24
Genuine Whirlpool part
By: Whirlpool
Part Number: W11162115
Burner stuck on high or won't regulate temperature? The infinite switch controls heat levels. Common DIY repair, typically 10 minutes to install.
Do-It-Yourself Stories from Customers like You
Burner stayed on high when moved to lower heat setting David L. • Melrose , MA • December 27, 2019
I watched an 8-minute video on YouTube. Identified and ordered the part from AppliancePartsPros that a $12 shipping fee was received in 2 days. Took 10 minutes or less to install. Years ago without next-day parts and YouTube, this $60 repair would have cost me $200+.
Read more
More
$78.27
- Compare At:
-
$92.36
- You Save:
-
$14.09
Genuine Whirlpool part
By: Whirlpool
Part Number: W11684512
The Screw is an OEM replacement part for Whirlpool ranges. This screw is used to secure various components of the range, ensuring that parts such as panels, brackets, or burners remain firmly in place during operation. It is designed to withstand the high-heat environment of a range, providing long-lasting durability.
Symptoms of a bad or missing Screw include:
- Loose or misaligned range components
- Rattling or unusual noises during operation
- Difficulty maintaining the range's structural stability
Causes of a failing or missing screw can include normal wear over time, accidental loss during maintenance or repairs, or damage from overtightening. Replacing faulty screws ensures the appliance remains safe and functional.
This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.
Do-It-Yourself Stories from Customers like You
Broken dryer baffles Ann B. • Bridgeport , NY • September 20, 2014
I am a 78year old woman and 40 years ago I replaced the belt on a dryer but could not even consider such a feat today. I ordered the parts from you on line and also found the video that you very nicely have attached to the site and I saved this under my favorites. The baffles arrived within 3 days and due to my age was unaware that dryers now come in two sizes and the ones I ordered were for the smaller but same model. I worked with a very nice customer service agent on line who got me the...
Read more
More
$13.95
- Compare At:
-
$15.68
- You Save:
-
$1.73
Genuine Whirlpool part
By: Whirlpool
Part Number: WP22001656
This is the washer's water level switch that senses tub level via air pressure and provides five selectable fill settings. Replacing a failed switch restores accurate filling and lets the cycle advance properly through wash, rinse, and spin.
- Monitors air pressure from the tub to detect actual water level
- Controls the inlet valves to start/stop filling at the selected setting
- Signals the timer/control to begin agitation and advance the cycle once full
- Common symptoms: overfilling or water keeps running, stops filling too soon or won't fill, inconsistent water levels, cycle won't advance due to incorrect level detection
What's included: 1 water level pressure switch with 5-position rotary selector Install notes:
- Disconnect power and turn off water supply before servicing
- Access the control console; remove the selector knob/dial and panel as needed
- Note wire locations (take a photo), move the harness, and transfer the pressure hose; ensure the hose is clear and firmly seated
- Securely mount the new switch, reassemble the console/knob, restore utilities, and test each fill level
Do-It-Yourself Stories from Customers like You
Water level in Maytag washer was always high and was not adjustable Von D. • San Bernardino , CA • December 21, 2017
Replaced the water level switch and water level pressure switch hose. Video on AppliancePartsPros.com detailed the procedure.
Read more
More
$127.65
- Compare At:
-
$153.18
- You Save:
-
$25.53