Knob Parts

1) Unplug the range and move it out from the wall so both the front and back are accessible. 2) Remove the control panel. There are two screws in the front, one under each end. A shorty Phillips screwdriver is handy here. On the back, find the four 1/4-inch hex-heads that hold the panel. The two on the end must be removed; the two in the middle could be loosened, but I found it just as easy to remove them and get them out of the way. 3) To free the controller itself, remove the two Phillips... Read more

I order the parts from 'Appliance Parts'. They were well-priced, and arrived on time. All I had to do was remove the old knobs, and install the new ones. Read more

We ordered four replacement knobs from you folks, and installed two of them, keeping the other two as spares. Read more

Replaced with new knobs, which turns the spindles & lights the burners. Read more

Took door off, saw that dispenser linkage was ok, I could open and close by hand, so figured the wax motor or the wiring to it were most likely the problem. I took off the wax motor ( actuator) and ran 120 volts to it via jumper wires, and it did not move at all, so figured good chance that was the problem. Found part # on your site, received new one quickly from you, put it in and works great. Thanks. Read more

They arrived in two days. They are exactly what I needed. Thank you. Read more

I replaced defrost timer (which I am glad I did because of wear on the points) but that did not cure the problem. So after checking other components, I found that the temperature control was the culprit. No problem, I will simply order part # 2162521100. Well Frigidaire decided to obsolete that part and "Has not provided an approved substitute". So, I have to scrap this freezer and pay $800 to $900 for a new one? Not! So I kept looking at subsequent freezer temperature controls and found part #... Read more

The grommet was old and very caked with old dishwasher scum. So water was leaking through where the soap door latch goes into the door. I replaced the rubber grommet (and the plastic latch that came with the kit, even though the old one was probably fine). Fit perfectly and looked just like the old one. Works like a champ, no leaking! Read more

1) Unscrewed the metal pieces behind the switch panel. You'll notice 3 screws. Afterwards, I realized that I just needed to remove the screws to the left and right of the switch box. The box then slides out. If you take out the third that connects the box to the wire cover, just remember to screw that back in before you replace the box. 2) To make sure I didn't place the wiring in the wrong place, I basically took the wiring out one by one and placing it into the new switch. 3) Place the new... Read more

Ordered a new knob and bezel. Both worked perfectly and the hood looks good as new. Read more

It went very well and want to thank you for your prompt and professional response. Read more

R R the knob Read more

Bought replacement knobs, removed broken ones and installed new ones. Read more