Briggs Stratton Small Engine Start Switch Parts
Genuine Ge part
By: Ge
Part Number: WR09X10105
Fridge won't cool and makes clicking sounds? The compressor overload may have failed. Protects against overheating. DIY repair takes 15-45 minutes.
Do-It-Yourself Stories from Customers like You
Tripped circuit breaker the no cooling or operation Dennis L. • Prague , NE • October 27, 2019
I replaced the overload which was burned up by constantly resetting because the condenser fan motor was not running properly so I replaced that as well.
Read more
More
$51.46
- Compare At:
-
$61.24
- You Save:
-
$9.78
Genuine Lg part
By: Lg
Part Number: 0CZZJB2014G
This capacitor stores and releases electrical energy to support the appliance's circuit during startup and operation. Replacing a weakened capacitor can restore reliable performance and reduce humming, hard starting, or stalling in the affected component.
- Provides a power boost at startup and helps stabilize voltage during operation
- Helps the connected component start promptly and operate smoothly under load
- Common failure signs include humming, slow or no start, or intermittent operation
- Contribute to overheating or a tripped breaker/fuse when the component tries to start
What's included: One capacitor. Install notes:
- Disconnect power at the breaker or unplug the appliance. Before handling, safely discharge the old capacitor using a proper resistor-rated tool.
- Photograph or note wire positions; move each lead to the same-labeled terminal on the new capacitor and ensure snug connections.
- Mount the capacitor securely in its bracket; keep terminals covered and clear of metal surfaces.
Do-It-Yourself Stories from Customers like You
Loud clicking from the back of my refrigerator Randy W. • Granbury , TX • March 04, 2015
Research question lead to others that had the same issue. Consensus lead to a common repair. Compressor overload switch going bad. After ordering the correct parts, I changed out both the switch and the motor start capacitor just in case. After cleaning the equipment, I then put everything back together. Results were, clicking gone, seems to be quieter operation because of cleaning, more efficient cooling and nerves calmed.
Read more
More
$43.79
- Compare At:
-
$52.11
- You Save:
-
$8.32
Genuine Frigidaire part
By: Frigidaire
Part Number: 134762000
Fix E32 error codes or washer stopping during fill with this water level pressure switch. Senses water level and controls fill cycles. DIY-friendly repair.
Do-It-Yourself Stories from Customers like You
Washer would stop after about 30 second on fill cycle diagnostic code of e32 Kenneth B. • Friendswood , TX • June 04, 2016
The E32 diagnostic code that the Frigidaire washer was throwing after a quick water fill attempt was not in the supplied Data Sheet that came with the washer and Frigidaire would not provide and updated Data Sheet because, "it's a liabiliity issue" was their statement, but they did tell me that the problem was in the Fill Pressure Sensor/Wire Harness or the Main Control Board (the display board). I ordered the Pressure Sensor and Main Control Board from AppliancePartsPros after checking...
Read more
More
$89.74
- Compare At:
-
$106.79
- You Save:
-
$17.05
Genuine Frigidaire part
By: Frigidaire
Part Number: 241835505
Interior light won't turn on when door opens? This push-button door switch restores automatic lighting. Moderate DIY repair with basic tools.
More
$87.95
- Compare At:
-
$105.54
- You Save:
-
$17.59
Genuine Frigidaire part
By: Frigidaire
Part Number: 316219019
This wiring harness routes power and control signals between key components inside your range or wall oven. Replace a damaged harness to restore safe, reliable operation and prevent intermittent heat, shorts, or non-working burners and oven functions.
- Distributes electrical power and signals between controls, switches, heating elements/igniters, and safety components
- Maintains correct connector orientation and wire routing for dependable operation
- Typical symptoms: no heat in oven or on surface burners, intermittent operation, breaker tripping, or visible burnt/melted wiring
- Restores stable connections to reduce arcing and overheating
What's included: One wiring harness assembly. Install notes:
- Disconnect power at the circuit breaker; for gas ranges, also shut off the gas supply
- Label or photograph all connections and transfer one wire at a time to avoid miswiring
- Route the harness exactly as original; keep away from sharp edges and hot surfaces; secure with existing clips/ties
- If connectors don't match or any terminals are heat-damaged, stop and inspect mating components.
Do-It-Yourself Stories from Customers like You
One of the burners wasn't doing the ignition Juan Carlos A. • Brooklyn , NY • October 30, 2016
Replaced the wiring harness
Read more
More
$74.31
- Compare At:
-
$87.69
- You Save:
-
$13.38
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304491942
Refrigerator not cooling but running? This compressor start relay and overload kit fixes weak or failed start components. DIY repair in 20 minutes.
Do-It-Yourself Stories from Customers like You
Bad start relay David S. • Knoxville , TN • July 12, 2015
Wake up the morning after a big fourth-of-July cookout to find the refrigerator is running, but not cooling any more. Wife is mad, food is spoiling, and the kitchen is littered with every cooler in the house. No repair person can come by to look at the refrigerator for at least five days. I narrow down the problem to the start relay and I was able to find the exact part on AppliancePartsPros.
With two-day shipping, I get the part fast, and the kit came with everything I need (and then...
Read more
More
$97.61
- Compare At:
-
$116.16
- You Save:
-
$18.55
Genuine Whirlpool part
By: Whirlpool
Part Number: WP4456836
This blower speed switch lets you select the blower/fan speed to restore proper airflow control in your appliance. It replaces a worn or faulty speed selector so the blower will respond correctly when you change settings. What it does:
- Controls the blower/fan speed so the appliance can run at selectable airflow levels
- Replaces a switch that is stuck, unresponsive, or only running at one speed
- Restores reliable electrical connection between the control circuit and blower motor
- Helps eliminate intermittent fan operation or loss of speed selection
What's included: One blower speed switch Install notes:
- Disconnect power to the appliance before starting any repair.
- Verify wiring placement and retain original fasteners; wiring diagram for correct connections.
- Handle terminals carefully to avoid bending or damaging contacts.
Do-It-Yourself Stories from Customers like You
Broken fan switch on my kitchenaid electric cooktop Joseph H. • Winter Haven , FL • May 12, 2014
Went on line to find the part number. Once I had the number I searched for the part. Found it, had it shipped overnight and installed it with the help of a video from youtube.
Read more
More
$120.56
- Compare At:
-
$143.47
- You Save:
-
$22.91
Genuine Frigidaire part
By: Frigidaire
Part Number: 154852501
This is the user control and display board located on the front panel of the dishwasher. It contains the buttons, display, and interface circuitry that allow you to select wash cycles, options, and monitor cycle status. Replace this board if the display is blank or flickering, buttons are unresponsive, or the dishwasher does not respond to cycle selections.
Do-It-Yourself Stories from Customers like You
Dishwasher electronics experiencing intermittent failures then complete failure i had power to the control board but no lights on panel etc Stephen H. • Fort Lauderdale , FL • July 12, 2016
I spoke with one of your sales people... ordered the control board and also the button board... ( for $50.00 , I'll replace it too while I'm in there ) .. The boards were here the next day, I installed them and the machine works better than ever ! Easy fix... outstanding sales lady, immediate delivery.
Read more
More
$113.95
- Compare At:
-
$135.60
- You Save:
-
$21.65
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2183456
Refrigerator not cooling or compressor won't start? This overload protector prevents motor damage from overheating. DIY-friendly fix in under 30 minutes.
Do-It-Yourself Stories from Customers like You
Refrigerator stopped working Patrick H. • Walland , TN • July 04, 2016
Used a muiltimeter to test all parts and ohm'ed out all parts. found out condenser fan motor seized up [open winding in motor] replaced that, and found that also caused the compressor overload and relay to fail, from over heating and over cycling, replaced both parts, powered up the refrigerator retested all electrical parts checked amp reading on all parts under load conditions,works good know, hope to get another 15 years out of this refrigator, its a maytag. over 20 years old.
Read more
More
$68.95
- Compare At:
-
$82.05
- You Save:
-
$13.10
Genuine Ge part
By: Ge
Part Number: WR08X10015
Refrigerator clicking but not cooling? A failed overload protector can prevent compressor startup. This part interrupts power during overheating.
More
$42.61
- Compare At:
-
$53.84
- You Save:
-
$11.23
Genuine Ge part
By: Ge
Part Number: WR8X122
Compressor won't start or kicks out after trying? This overload protector prevents motor damage. DIY-friendly repair, takes about 30 minutes to replace.
Do-It-Yourself Stories from Customers like You
Cooling fan runs but compressor tries to start and kicks out Dave F. • Painesville , OH • November 10, 2015
I read alot of blogs about the same similar symptom, but none described by exact problem. I kept reading how the compressor relay would make a click noise or sisal. I also found out the overload switch could cause a like symptom. The end result being that upon removal of the relay, it was discolored and made a rattling noise when shook. The overload switch was heat cracked on the plastic and looked like it had had enough. This was easily accomplished by using the repair mans print out for the...
Read more
More
$53.95
- Compare At:
-
$64.74
- You Save:
-
$10.79
Genuine Whirlpool part
By: Whirlpool
Part Number: 12002794
Refrigerator making clicking sounds and not cooling? This overload relay kit fixes compressor start problems. Easy DIY repair—pull off old relay and install.
Do-It-Yourself Stories from Customers like You
My compressor relay on my refrigerator failed Jared W. • Mchenry , IL • February 19, 2015
I was able to pull off the old relay and swap out with the new relay. Everything went together perfectly.
Read more
More
$111.44
- Compare At:
-
$132.61
- You Save:
-
$21.17
Genuine Ge part
By: Ge
Part Number: WB23K34829
The Infinite Switch is an OEM part for GE electric ranges. It regulates precise temperature settings for the bake and surface elements. This is specifically for 6" inch elements.
Symptoms of a bad infinite switch include:
- Wide variations in cooking temperatures
- Failure to attain or maintain desired heat levels
- Non-working or faulty temperature selector dial
Causes can involve degraded metal contacts, worn internal components, or damaged wiring connections after extended use.
This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore electric range models.
Do-It-Yourself Stories from Customers like You
The red "burner on" signal light was on when all switches were turned off 3 of the 4 burners would heat up but one 8 inch burner would not heat and inspection showed a burned switch easy repair Harley W. • Holt , MO • January 10, 2015
Replaced the switch.
Read more
More
$56.95
- Compare At:
-
$67.20
- You Save:
-
$10.25
Genuine Whirlpool part
By: Whirlpool
Part Number: WP74011243
Burner stuck on high or won't heat? The infinite switch controls surface element power from low to high. Common DIY fix restores heat adjustment.
Do-It-Yourself Stories from Customers like You
No control of range burner burner was either off or on high no heat adjustment Robert B. • Toms River , NJ • September 06, 2014
Replaced infinite switch
Read more
More
$73.95
- Compare At:
-
$88.00
- You Save:
-
$14.05
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10168257
Fix a washer that won't advance cycles or gets stuck between rinse and spin. This cycle selector switch controls washing cycle progression.
More
$77.76
- Compare At:
-
$92.53
- You Save:
-
$14.77
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10215034
Fixes dual burner stuck on high, won't heat, or no inner ring control. This infinite switch restores precise temperature selection. 45-60 minute DIY repair.
Do-It-Yourself Stories from Customers like You
Burner didn't turn on Bruce H. • Granger , IN • August 18, 2015
I replaced both the element and the switch. It was a relatively easy fix, although I needed a second set of hands to hold the stovetop upright while I did the replacement. The entire job took about 45-60 minutes.
Read more
More
$161.78
- Compare At:
-
$190.90
- You Save:
-
$29.12