Turn Power Small Engine Regular Starter Parts

This is a compressor overload protector that prevents the compressor motor from overheating by cutting power when excessive current or temperature is detected. It attaches directly to the compressor and is a critical safety component. Replace this part if the compressor fails to start, cycles on and off repeatedly, or if the refrigerator stops cooling entirely.

Refrigerator clicking but not cooling? A failed compressor overload protector prevents the compressor from starting. This part restores normal operation.

Guardette (right) is a replacement right-side protective guard used on select GE refrigerators. It restores the interior guard/trim that protects components and helps keep the cabinet interior aligned for smooth door and shelf operation. What it does:

• Replaces a cracked, broken or missing right-side guard to restore proper coverage and protection
• Shields interior wiring and components from contact and everyday wear
• Helps prevent items from catching on damaged trim and reduces rattles or misalignment
• Matches OEM fit and mounting points for a straightforward replacement on compatible units

• Disconnect power to the appliance before starting any repairs
• Removal may require gently prying or unsnapping the old guard; use a trim tool to avoid damage
• Align mounting tabs and press firmly until the replacement snaps into place
• If fasteners are present, tighten by hand to avoid cracking plastic

Dryer not heating or leaving clothes damp? This thermostat with sensing cable regulates temperature and prevents overheating. Easy DIY repair part.

A 15 amp cartridge fuse that protects appliance electrical circuits from overcurrent, helping prevent damage to controls and components. Fits into inline fuse holders or boards where that specific fuse rating is required. What it does

• Interrupts circuit power when current exceeds 15 amps to protect wiring and electronics
• Commonly linked to symptoms like no power to controls, unresponsive display, or appliances that won't start
• Designed to be replaced when visibly blown or when continuity test fails
• Works as the exact rated safety fuse specified for compatible appliances

• One 15 amp cartridge fuse

• Disconnect all power to the appliance before accessing or replacing the fuse
• Replace with the identical fuse type and 15 amp rating only; do not substitute different ratings
• Handle carefully and mount fully seated in its holder or on the PCB as designed
• If the new fuse fails again immediately, stop — repeated failures indicate underlying electrical faults

If your range control panel is unresponsive or the display won't light up, the control transformer may have failed. Supplies low-voltage power to controls.

Broken selection knob or exposed switch opening? This dryer finish guard covers and protects the control switch area. Moderate difficulty repair.

Fix a refrigerator that won't cool or clicks without starting. This PTC starter relay helps the compressor engage properly. DIY repair in under 30 minutes.

Dryer not heating properly or overheating? This temperature switch regulates heat levels to restore safe, effective drying. Simple DIY repair.

Fix a dryer that won't heat properly or overheats. This cycle thermostat regulates temperature during heating cycles. Easy DIY repair in under an hour.

Dryer won't heat or overheats? This thermostat regulates temperature during drying cycles. Easy 15-minute DIY fix restores proper heat control.

This is a replacement fluorescent lamp starter designed for use with 80W, 240V fixtures. It helps the lamp reach full brightness reliably so lighting cycles start and run normally. What it does:

• Provides the initial pulse to ignite fluorescent tubes in compatible fixtures
• Commonly restores lamps that fail to start or take multiple strikes to light
• Can stop or reduce continuous flickering or rapid flashing at startup
• Works with starter-type ballasts specified for 80W / 240V operation

• Disconnect power to the fixture before servicing to avoid shock
• Typically replaces a plug-in starter in the fixture's starter holder—pull old starter straight out and push the new starter into place
• Confirm fixture voltage and lamp wattage match the starter specifications before installing

Fix a loud humming or buzzing noise from your wall oven control panel. This low-voltage transformer powers the control board and related circuits.

Refrigerator not cooling or compressor not starting? This overload relay kit protects the compressor from electrical overload. Moderate DIY repair.

This is a compressor start device that helps the compressor motor start up by providing the initial electrical boost it needs. It combines the functions of a start relay and overload protector in one unit. Replace this device if the compressor won't start, the refrigerator or freezer isn't cooling, or you hear a clicking sound followed by the compressor shutting off repeatedly.

Refrigerator compressor buzzing but not starting? This start relay and overload protector fixes clicking sounds and warm temps. DIY-friendly repair.