Tank Ce Small Engine Start Switch Parts
Genuine Ge part
By: Ge
Part Number: WB23K34829
The Infinite Switch is an OEM part for GE electric ranges. It regulates precise temperature settings for the bake and surface elements. This is specifically for 6" inch elements.
Symptoms of a bad infinite switch include:
- Wide variations in cooking temperatures
- Failure to attain or maintain desired heat levels
- Non-working or faulty temperature selector dial
Causes can involve degraded metal contacts, worn internal components, or damaged wiring connections after extended use.
This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore electric range models.
Do-It-Yourself Stories from Customers like You
The red "burner on" signal light was on when all switches were turned off 3 of the 4 burners would heat up but one 8 inch burner would not heat and inspection showed a burned switch easy repair Harley W. • Holt , MO • January 10, 2015
Replaced the switch.
Read more
More
$56.95
- Compare At:
-
$67.20
- You Save:
-
$10.25
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10168257
Fix a washer that won't advance cycles or gets stuck between rinse and spin. This cycle selector switch controls washing cycle progression.
More
$77.76
- Compare At:
-
$92.53
- You Save:
-
$14.77
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10215034
Fixes dual burner stuck on high, won't heat, or no inner ring control. This infinite switch restores precise temperature selection. 45-60 minute DIY repair.
Do-It-Yourself Stories from Customers like You
Burner didn't turn on Bruce H. • Granger , IN • August 18, 2015
I replaced both the element and the switch. It was a relatively easy fix, although I needed a second set of hands to hold the stovetop upright while I did the replacement. The entire job took about 45-60 minutes.
Read more
More
$161.78
- Compare At:
-
$190.90
- You Save:
-
$29.12
Genuine Whirlpool part
By: Whirlpool
Part Number: 12002121
If your cooktop burner only works on high or won't adjust temperature, the infinite switch likely failed. DIY-friendly repair in under 30 minutes.
Do-It-Yourself Stories from Customers like You
Right front double burner only worked on high!!!! Rolland F. • Brasher Falls , NY • September 21, 2014
Ordered the part and a few days later it arrived and I turned off the power and took a few screws out and unpluged the old one and pluged in the new .. Works like a charm.. Was very easy to fix....
Read more
More
$79.74
- Compare At:
-
$94.89
- You Save:
-
$15.15
Genuine Frigidaire part
By: Frigidaire
Part Number: 241707709
Refrigerator clicking but not cooling? A failed compressor starter prevents reliable startup. This part restores proper cooling by helping the compressor start.
More
$70.95
- Compare At:
-
$84.43
- You Save:
-
$13.48
Genuine Lg part
By: Lg
Part Number: EBF61734701
This micro switch is a compact, snap-action electrical switch that sends an on/off signal when a lever, latch, or paddle is moved. Replacing a worn switch restores reliable detection and control response for the affected function.
- Converts mechanical movement into an electrical open/close signal to the control
- Commonly used for lever/paddle actuators, latches, or interlock detection within the appliance
- Safe symptom clues: no response when actuated, intermittent operation, or a function stuck on/off
- Physical clues: weak or absent "click" when pressed, heat discoloration or damage at terminals
What's included: 1 micro switch
- Disconnect power before servicing; if the product is connected to a water line, close the supply valve
- Note wire positions and terminal labels (COM/NO/NC); transfer wires one at a time to matching terminals
- Match the actuator orientation and mounting position to the original for proper operation
- After installation, verify continuity with a multimeter and test function before reassembly
Do-It-Yourself Stories from Customers like You
Sensor on dryer and refridgeator bad Perry S. • Jackson , TN • November 14, 2015
Take section applicable apart, test and replace parts.
Read more
More
$21.72
- Compare At:
-
$26.06
- You Save:
-
$4.34
Genuine Ge part
By: Ge
Part Number: WH01X10621
Fix bleach pooling or uneven dispensing in your laundry center. This funnel directs bleach into the wash tub, preventing spills and odor issues.
More
$12.85
- Compare At:
-
$14.34
- You Save:
-
$1.49
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8543274
Dryer won't start when you press the button? This push-to-start switch closes the circuit to begin cycles. Easy DIY repair restores reliable starting.
Do-It-Yourself Stories from Customers like You
Start switch replacement George Z. • Sebastian , FL • December 14, 2020
I have an old dryer. My wife wanted a new washer and dryer but I keep repairing the old ones. Not because I have to, but because I want to, it's personal now. Can't let my old dryer beat me down. We have pushed that old Start-Stop switch so many times it just wore out. Bing-bang-boom...it was simple.
Read more
More
$56.34
- Compare At:
-
$67.04
- You Save:
-
$10.70
Genuine Ge part
By: Ge
Part Number: WR08X10015
Refrigerator clicking but not cooling? A failed overload protector can prevent compressor startup. This part interrupts power during overheating.
More
$42.61
- Compare At:
-
$53.84
- You Save:
-
$11.23
Genuine Bosch part
By: Bosch
Part Number: 00414750
Fix a range hood fan stuck at full speed or not working with a new speed control switch. DIY repair typically takes 15-30 minutes with basic tools.
Do-It-Yourself Stories from Customers like You
Fan worked but only at full speed. Bernard A. • Carmichael , CA • December 05, 2020
Turned off power. Removed cover over back of fan control switch. Unscrewed nut holding old switch in place. Removed clear plastic wire coverings. Hardest part of job. Photographed wires. Removed wires of old switch and replaced with wires from new switch. Had an extra green wire since old switch did not have a ground. Secured switch in panel with nut that came with it. Replaced cover on back of control switch. Turned on power and it now reduces the speed of the fan.
Read more
More
$132.31
- Compare At:
-
$156.13
- You Save:
-
$23.82
Genuine Frigidaire part
By: Frigidaire
Part Number: 216954200
This is a start relay device that attaches to the compressor and provides the initial electrical boost needed to start the compressor motor. It works in conjunction with the run capacitor to get the compressor running and then disengages once the motor reaches operating speed. Replace this device if the refrigerator is not cooling, the compressor clicks on and off repeatedly, or you hear a buzzing sound coming from the back of the unit.
Do-It-Yourself Stories from Customers like You
Trying to start and relay or overload just clicking off and on William K. • Morganton , NC • November 28, 2015
Works perfect now
Read more
More
$62.51
- Compare At:
-
$75.66
- You Save:
-
$13.15
Genuine Frigidaire part
By: Frigidaire
Part Number: 241707705
Refrigerator won't cool or compressor clicks but won't start? This PTC start relay powers the compressor's start winding. Common DIY fix, restores cooling.
Do-It-Yourself Stories from Customers like You
Both overload and run capacitor burnt out Sione T. • Washington , DC • September 02, 2017
I ordered the compressor starting device kit and run capacitor to replace the burnt parts. It works right off the bat! The parts are for a Kenmore fridge/freezer. Saves Money and a trip to Dumping place. Great product and great Price. This is the second time I fix friends fridge/freezer with this repair kit from this site. Great Service!
Read more
More
$48.95
- Compare At:
-
$58.74
- You Save:
-
$9.79
Genuine Frigidaire part
By: Frigidaire
Part Number: 808136601
This is a door-activated switch that detects whether the oven door is open or closed. It controls functions such as the oven light or signals the control board about door position. Replace this switch if the oven light stays on or off regardless of door position, or if the oven does not operate correctly due to a faulty door signal.
Do-It-Yourself Stories from Customers like You
Oven light would never turn off. Raul R. • Northlake , IL • March 15, 2018
Bought a door light switch from your company and used it to replace the bad one from my stove.
Read more
More
$52.46
- Compare At:
-
$61.90
- You Save:
-
$9.44
Genuine Whirlpool part
By: Whirlpool
Part Number: WP21001554
Fix washer overflowing or not stopping fill cycle. This water level pressure switch senses tub water and signals control to stop filling. DIY repair.
Do-It-Yourself Stories from Customers like You
Tub was overfilling and water would not stop until machine turned off replaved water level valve but did not solve problem Kirk N. • Oak Island , NC • April 19, 2014
Filled tub to about 6 inches and inspected washer. Noticed that the tube leading from the air entrapment bubble on the exterior side of the drum had a small leak in it. Clipped off the part of the tube that had the hole in it(it was very close to the connector nipple) reconnected and problem was solved.
Read more
More
$118.53
- Compare At:
-
$139.87
- You Save:
-
$21.34
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3148955
Fix a burner that won't turn off, stays on high, or won't heat. This infinite switch restores precise temperature control for electric cooktop elements.
Do-It-Yourself Stories from Customers like You
Electric burner control switch William F. • Teutopolis , IL • March 08, 2017
Turn the power off to the range. Pull off the black control knob. Remove 6 - 5/16 screws in back of the range behind the controls panel. Take out 2 screws (behind the control knob) in front that hold the control swirch in the panel. Remove each wire from the old switch and place it onto the new switch (one at a time)so get the wires are installed in the correct place. Make sure the wire are tight on the new switch. Install the new switch, put the two mounting screws in, reinstall the back, put...
Read more
More
$87.60
- Compare At:
-
$103.37
- You Save:
-
$15.77
Genuine Whirlpool part
By: Whirlpool
Part Number: WP74007806
Fix burners that won't light with this cooktop igniter switch wire assembly. Restores reliable spark ignition when switches fail. Moderate DIY repair.
Do-It-Yourself Stories from Customers like You
Three out of 5 igniter switches wouldn't work Marcus B. • Eads , TN • February 11, 2017
Replaced igniter switch harness
Read more
More
$102.35
- Compare At:
-
$121.80
- You Save:
-
$19.45