Hardware Hand Small Engine Safety Switch Parts

I replaced the keypad entry and it fixed the problem for 24 hours, but then it beeped and entered 0. But is much better than it was. I am an electronics tech and I know through the yrs 2000-2010 there were a rash of bad capacitors produced. I now believe a second board which has these capacitors is the source of the problem. I also believe the second board let voltage spikes through which slowly damaged the keypad board. My goal is to order the capacitors which cost less than a $1 each... Read more

Second repair after 10 years of service - igniter had cracked and spill overs were causing the others to misfire. This was a two-step process. I took apart the cooktop to see what parts were neded. Screws were all rusted, I had to drill ome out. The burner gaskets broke during the process and needed replacement. One of the burners had deformed due to excess heat. After that initial diagnose, I reassembled the cooktop without the igniters and ordered all the parts I needed. The second stage was... Read more

Replaced igniter under each burner knob. Used needle nose pliers to remove the electrical connections (2) of the igniter then slipped it off the gas valve shaft. Replaced with new igniter (click in place) and replaced electrical connectors. Took about 15 minutes to complete. Read more

I replaced an infinite switch and a simmer select switch. Read more

The constant cooking and age of the appliance I repaired corroded the housing attachment that holds the igniter in place to the burner. Also the screws that hold the burner in place to the stove cover were also corroded which caused the burner itself to not stay in place but fall into the stove. By using a screw driver, lift up on the sides of the stove cover to pop the clips that hold it in place. Use a block of wood to hold up the stove cover. On the model I worked on, the igniter removes... Read more

Bought these two pieces through Appliance Parts Pro - they matched exactly at half the cost. Shipped same day. Read more

I positioned the element under the top of the stove and placed it back in there with the bracket and screw. Turned out perfectly. Read more

Replaced shorted wire and blown switches. Read more

As described, thanks your helped repair what the repairman would not or could not do.. Bottom element shorted and burned up from previous homeowner, not sure why or how? Replaced both heating elements, still no heat, the clock controller was also damaged due to the shorting even though it appeared to work OK, just no heat. Replaced clock/controller , both elements and the temp sensor .ALL WORKING !!! Lots of scrubbing and now have a "new" oven.! Half the cost of the serviceman, Saved my oven... Read more

I ordered a replacement handle from Appliance Parts Pro.com and installed it after watching the video at their site for a similar model. The video told of the trick on removing the door surround that allowed me to access the handle screws. I purchased new handle screws at the same time I bought the new handle. The new handle and screws were a bit different than the original but fit perfectly. Hopefully it will be more durable than the original handle. Read more

Replaced the cold water valve unit (has 4 ports and 1 inlet) which is very straight forward; requires : 1 phillips screwdriver ~#2 1 needlenose plier, medium size 1 channel lock plier, medium size 1 marker pen 1 - cold water valve assembly # AP4445613 1 - hot water valve assembly #AP4441935 1 - water level pressure switch #AP4440713 an old towel or two for absorbing small amounts of water a cellphone / camera for making sure you have the... Read more

Replaced the ignitor glow bar and deflector oven (which had a hole burned through it). Screws stripped upon disassembly of original deflector oven and needed to be replaced as well. Read more