Run Vent User Control Display Board Parts

I noticed a lot of water on the floor one day. I had no idea where it came from (all pipes in the area near the stationary tub were dry, there was a small wet spot near the washer, but most of the water was more than 2ft from it). Started a small load and noticed water running down the outside of the unit. Immediately stopped the cycle and removed the front of the washer. Restarted the cycle and could see water spraying from the intake hose. Stopped the cycle and advanced it to spin to... Read more

• Freezer not defrosting
• Too warm
• Fridge runs too long
• Fridge too warm

I am not new to APP, fixed a tub belt on a Maytag dryer in the past. My frig started getting warm so I went onto to one of those "lists" sites and found a appliance repair place. The guys were great and came out right away. The tech said it was the cold control and $260 later my part was replaced, about 30 minutes. Great I thought until my frig started getting warm again. Those cold sensors on the beer bottles are a great indicator. Not wanting to spend another $260 I looked up on APP to see if... Read more

The parts I ordered from you worked and got hereon time, great job, and thanks again. I will. use you again in the future Thanks again Read more

Ordered a replacement. everything is working as it should. Read more

Replaced fan motor in fresh food section, easiest repair I have ever made, took longer to get shelves out than replacing motor.. Read more

• Touchpad does not respond
• Will not program

I found exploded parts view of oven and looked for oven sensor probe and control card parts. I also looked at great videos and read past repair stories. I decided the problem had to be one of the two parts (probe or card) and ordered both. I decided that the probe should be changed first rather than involve a circuit card. I changed the probe and tested the oven and it works again. Read more

Ordered a Pcb board and membrane switch it fixed the problem Read more

Ordered both parts and got them in 2 days, removed 3 screws on back panel of dryer and removed defective timer , installed wires on new timer and put back in place and installed new knob , very easy repair only took 10 minutes and dryer was back up and running Read more

Replaced timer, thermostat, a thermal fuse, the pair of thermal cutoff switches and finally the heater element. Hard to say what the final fix was that did the trick -- I am guessing it was the heater element although the old one appeared to have good continuity. All praise goes to the on line chat Pros Erica B and Robin C that took considerable amount of time and effort to help me decipher the problem. For that alone, Appliance Parts Pros will be my go to source for appliance parts for the... Read more

Replace defrost timer Read more

First I called the local retailer to ask about a non-warranty service. Minimum $100 charge. Figured I would take a shot at the repair as I had fixed the fridge once before. I used a digital thermometer to verify that the temperature in the ice maker compartment was at the right temperature. I put the ice maker in diagnostic mode to eject the ice that was sitting in the ice tray (turn off and on and then push the ice full lever three times). Ice was successfully ejected. Sometimes the ice... Read more

Replaced electronic control board and everything is back to working normally. Read more

Replaced timer. It's a snap in place timer, once you remove the defective timer, overall pretty easy. Read more

The video was very helpful. the hardest part is getting off old rusted parts. I had to use a hacksaw to remove one of the old clamps. I had to open the bottom of the washing machine to remove of the other clamp. Putting the new parts on was easy. Getting everything apart was a challenge. Putting the new parts on was an easy 5 minute job. Read more

Replaced the machine control board and user interface. Read more