Keypad Parts

Removed and unplugged dishwasher. Opened door and peeled off touch pad. Removed the screws that held the door together. Gently separated the inner and outer parts of the door. Removed the cable for touch pad. Fed new touch pad cable into door from top. And pressed cable back into fitting. Reassembled door. Plugged dishwasher back in and reinstalled into cabinet. Only one problem with my repair. I should have plugged in the “New” touch pad to see if it it worked properly. It has a led out on it... Read more

I bought the part from APP.com and the replacement was simply. I pulled it into the receptacle, put the door back together and then adhered the new keypad to the door. This tool about 30 mins in total and only need a putty knife to remove the old one and a screwdriver to put the door back together. Probably saved myself a $200-$300 labor repair cost. Read more

Replaced the control panel (Timer). Getting it out is a bit of a puzzle but doable. Read more

This is an oven with keypad directly above oven door. And needed to replace the keypad and housing. Pretty easy fix. first turn oven off at breaker and unplug unit. Second pull off top burner knobs and remove 2 screws that are hidden behind each knob. 4th remove housing screws (1 screw on each side of housing and 4 screws on bottom of housing). 5th pull out housing and disconnect all wire connectors from mother board. They are labeled and color coded). There are also 4 small red lights.These... Read more

Researched what parts were needed using resources in ApplianceParos.com website. Contacted support to verify if I had identified the correct parts to be replaced. Ordered the part and it arrived within 24 hours. Watched the video on the website and followed instructions to replace the part. Completed the work. Read more

I replaced the control panel. I guess the problem could also have been the control board. I felt more certain about purchasing the control panel after removing the old one, and ohm-ing out pins that should have indicated small resistance when pressing front panel buttons, but all indicated open circuit. A result of moisture that ruined the thin wires in the ribbon cable, apparently a common problem of the Maytag/Whirlpool dishwashers and the subject of a class action lawsuit (Maytag would... Read more

I removed the control block and carefully removed the damaged faceplate using a sharp knife and a hair dryer. Read more

Ordered and installed new touchpad from AppliancePartsPros.com, just like I did 9 years ago. Read more

Ordered a new control panel and installed it; The repair is super easy and it would not take more than 10 minutes were I to do it again but because I had never done anything like this before I got stuck at one point and it took me a lot longer. I could not figure out how to get the electrical box off the old control panel - it was just a matter of bending the middle part of the plastic clips but I had not seen that kind of clip before and it was not immediately evident. I was afraid to force... Read more

Maytag Dishwasher (about 5 years old). Some of the buttons had stopped functioning. Then the Start button began choosing whether or not to work. Eventually it would not start at all. Upon removing the control panel, the first thing I noticed was that the brackets that hold the two lower screws were broken. (So this was the reason that the door was so hard to open from the time it was new.) I trouble shot the thermal fuse, the door-latch switches, and inspected the control board trying to find... Read more