We use cookies and similar tools for site analytics and advertising. By using our site, you agree to this. See our Privacy Policy for details. Do Not Sell or Share My Personal Information
Need Help?
Call
Fix a detergent dispenser that won't open or leaks rinse aid. Replaces the complete dispenser assembly. Moderate DIY repair with video guide.
Replaced dispenser Read more
Dispenser door won't open or stay closed? This dishwasher dispenser releases detergent and rinse aid at the right time. Moderate DIY repair.
Process was a bit more complicated than the videos I had watched online. Had to remove both front panel and control panel to get to soap dispenser. Removed wires to soap dispenser and rinse aide dispenser. Removed wire "harness" around the top and right side of dispenser. Pried back the clips to allow dispenser to be pushed out. It was helpful to have another person to hold the door open at this point. Bent clips back and reinstalled everything. New part works great. Read more
Fix a rinse aid door that won't stay closed or causes leaks. This dishwasher dispenser door with gasket snaps on in minutes. Easy DIY repair.
Twist the old one out, insert tab, twist until other side snaps in. Easy as pie after watching the video! Read more
Detergent dispenser door won't stay closed? This latch secures the detergent cup during wash cycles. Simple DIY repair with video guidance included.
After having seen the video I installed the new lid and it worked. Read more
Fix a detergent dispenser door that won't stay closed or pops open during the wash cycle. This lid replacement is a simple DIY repair with no tools needed.
Closes a designated opening on your dryer, shielding internal components from dust and debris. Replace if cracked, warped, broken, or missing hinges.
The new plastic cover came sooner than expected and the dryer looks like new again. Read more
Plastic cover that protects the drain pump mechanism from debris. Replace if cracked, broken, or tabs are bent preventing proper seal during drain cycles.
Watched AppliancePartsPros video, disassembled the dishwasher and replace impeller and seals. Read more
Detergent door won't close or stay shut? Replace the dispenser assembly. Takes about 20 minutes with basic tools—remove inner door panel and swap out.
Removed back of dishwasher with hex screw driver 5 min Unplugged power cord 30 secs Loosened metal bracket on top and bottom with screwdriver 5 min Pushed dispenser in and removed from dishwasher 5 min Positioned new unit in space and snapped into place 1 min Plugged electrics back in 1 min Screwed back on 3 min Roughly 20 min. I am nontechnical and rarely do repairs. Read more
Wax motor for detergent/rinse-aid dispenser.
Took door off, saw that dispenser linkage was ok, I could open and close by hand, so figured the wax motor or the wiring to it were most likely the problem. I took off the wax motor ( actuator) and ran 120 volts to it via jumper wires, and it did not move at all, so figured good chance that was the problem. Found part # on your site, received new one quickly from you, put it in and works great. Thanks. Read more
Secures the water filter in your refrigerator for a snug, leak-free fit. Replace if lost during filter changes, cracked, damaged, or worn out over time.
Rear pump housing for the washer drain/pump assembly. Replaces the worn rear housing that supports the impeller and bearing, helping restore proper draining and reduce leaks or unusual pump noises when the housing fails. What it does:
Our Bosch suddenly quit washing the dishes properly after 15 years of faithful service. I observed that there was no pressure coming from the sprayers, and determined it to be the circulating pump. I could reach into the pump from inside the dishwasher and could feel that something was loose in there - the impeller moved when pumping, but I could stop it with my finger. When I took the pump out and disassembled it, the impeller was in two pieces (the front and back pieces that are supposed... Read more
Pump housing cover for dishwashers. Replaces cracked, broken, or missing covers that protect the pump assembly. Installs over the pump mechanism.
Replacement blender lid with removable center insert. Seals the blender top to contain ingredients during blending. Needed when original is cracked or missing.
Replaces a cracked, broken, or missing detergent dispenser cover on your dishwasher. Snaps onto the dispenser assembly to keep detergent secure.
Replace your dishwasher's detergent dispenser lid if it's cracked, broken, or missing. This cover installs on the dispenser assembly to seal properly.
Bought new dispenser lid with gasket and installed in despensor! Read more
Replacement water level control cover for dishwashers. Snaps over the water level control assembly. Order a new cover if yours is broken, cracked, or missing.