Rgb540sepsa Parts

• Little to no heat when broiling
• Little to no heat when baking
• Gas igniter glows, but will not light
• Won't start

If the oven burner would not light but the broiler would this indicated that the safety valve is OK. Problem had to be with the igniter. Removed the bottom panel in the oven and restarted the oven. The igniter would not glow at all. It should be brilliant red. This is where the problem came in. I could not find the location of the model on the Kenmore range anywhere you would normally look - the back, the wiring envelope, the oven door jamb etc. Also the igniter cannot be removed from... Read more

I have a Jennair jjw9630cas double wall oven, and after a few years I noticed that the light would not go out, first in the bottom oven, and then in the top oven. After doing some research I discovered this was not uncommon, and the fix usually involved replacing the hinges and/or the hinge receptacles. It didn't look like a difficult fix so I ordered four new hinges and four new receptacles, which arrived quickly. I found a video on YouTube that showed how to replace the hinges and it... Read more

Ordered New Gasket and installed in about 3-4 Minutes. Only need small pliers to remove some of old clips from holes. New Gasket clipped in easily by hand. Read more

Orded rack by stove model number. fit perfect Read more

Cleaned/ soaked all burners in Ammonia and scraped off the remaining with a pumice stone. Oiled all screws. Replaced (4) ignitors or electrodes and module kit/ right front burner/ burner switch harness. Although this was the third order of switches from 3 different places including the local supplier due to the switches being manufactured upside down and lit on low on the first attempt. (Since I was going to have to open it up again to either repair or remove and return the upside-down harness... Read more

• Won't start

Took off old, replaced with new. Cross reference worked well, all GE parts. Saved a lot of money compared to local supplier. Read more

I called AppliancePartsPros.com gave them my model number and the representative was very knowledgeable, and ordered the right parts for me. I received my parts within a couple of days. Read more

I BOUGHT NEW BURNERS FRM YOU. EXCELLENT PRICE, SHIPPING ARRIVAL, PARTS WERE ORIGINAL GE PARTS. TY Read more

• Oven is too hot
• Little to no heat when baking
• Won't start

The repair was relatively simple and quick. The only part required was a new oven thermostat assembly and the tools I used for my model was a flathead screwdriver, cross-point screwdriver, torque bit and 1/4 inch socket using a bit driver. To complete the repair, I did the following: 1. Remove all top stove burner pieces and place to the side. Remove the 3 three screws (torque bit) in each of the 4 burner locations. That will allow the top lid to separate from the main unit later. 2. Pull... Read more

Removed 2 outer screws that held on handle and 4 inner screws which held on handle to outer panel. Installed new handle with 4 screws and installed outer 2 screws with spacers which were in door. Read more

I was getting really frustrated with our oven. It would preheat to the correct temperature, then slowly lose heat until it was down to about 200 degrees. So it took about two hours to heat a pizza! Finally decided to repair the oven myself, rather than pay $300.00 to have a repair person come out. Ordered the replacement igniter from AppliancePartsPros.com, and it arrived in two days. I followed the instructional video on the AppliancePartsPros.com website, and it was going well until I... Read more

Once I watched the video on your site about gas line install, it became apparent why the line bent when I raised the lid.. also discovered those two rods have nest to go into and the lid/top now sets down tight as designed ( and as an added bonus, gas smell disappeared during oven use) I ordered the gas lines with the model number, ordered all four …. it was a bit of a chore one came up when site opened I picked it, but did not know if it was the RH or LH etc.. so reading some of your answers... Read more

Fast delivery, great service Read more

Fixed it by replacing Valve Control Assemble and Range Oven Igniter, a little intimidating at first,but the videos from Appliance Parts Pro made so much easier.Whenever I need parts for appliance in the future AppliancePartsPros will be my first choice. Read more

I watched a video on this web site, which was great. Just had to familiarize myself where the parts are on my stove. It took longer than a pro, but I didn't have to pay for a service call and the parts were cheaper, too. It was just a bit more difficult than changing a light switch. Read more

Called Appliance Parts - service agent was extremely helpful. Tried to find an assembled piece was unable to do so. Send me the individual parts which were very easy to assemble. Was able to replace entire light assembly, reconnect wire with new terminal end. Light works find just now. Would definitely call again if I needed assistance. Read more