Whirlpool W10811169 Panel-Cntl (Stl) OEM Part

This is a relatively easy repair. Here are detailed instruction to replace the Control Panel. Tools Required: #15 and #20 Torx drivers. (Power tools not recommended) THE INNER SHELL DOES NOT HAVE TO BE COMPLETELY REMOVED There are 10 perimeter screws that secure the inner shell (#15) to the outer shell and six screws, three on each side (#20). Two of these screws secure the Controller Bracket and 4 that secure the spring loaded hinge to the inner shell. These six screws don't have to be removed. One interior screw (#20) that secures the Control Panel to the Control Bracket. 1. Turn off power to the dishwasher. 2. Open the door all the way and remove the 10 perimeter screws 3. Close the door half way and separate the inner shell from the outer shell. There should be enough room to access the harness plug and the interior screw. If not, gently pry the two apart so there's enough room for your #20 Torx driver, 4. Unplug the harness and remove the interior screw. (Centered just below the Control Panel). Remove the Control Panel. 5. Remove the pull handle from the old Control Panel and install it into the new one. 6. Attach the new Control Panel to the inner shell with the four screws previously removed. Reinstall the inner screw and install the harness plug. 7. With one hand, pull up on the outer shell from the bottom so the shell slides into Control Panel and is flush. 8. While holding the outer shell in place, install the top right and left perimeter screws. You can now open the door all the way. 9. Install the remaining perimeter screws top to bottom. 10. Turn on power to dishwasher. 2.

Looked on the internet, found videos on repair problems, decided what needed to be replaced. ordered a new control panel, replaced and solved the problem.

Purchased a replacement control panel from Appliance Part Pros, took less than two days to ship, and less than 20 minutes to install new part.

With help about this trouble from their pro's ordered and replaced control panel. my daughter is a happy.

Remembering this Maytag had several service calls and the control panel finally replaced under warranty, plus the fact that web research was abundant with Maytag control panel failures, I simply ordered a new control panel. When the new panel was installed, dishwasher ran fine. Broken wheel was ridiculously expensive to buy new so temporarily repaired with epoxy and am researching generic replacement/cross reference to wheels for other models that are much more reasonably priced.