Rb150avl Parts

I have a Jennair jjw9630cas double wall oven, and after a few years I noticed that the light would not go out, first in the bottom oven, and then in the top oven. After doing some research I discovered this was not uncommon, and the fix usually involved replacing the hinges and/or the hinge receptacles. It didn't look like a difficult fix so I ordered four new hinges and four new receptacles, which arrived quickly. I found a video on YouTube that showed how to replace the hinges and it... Read more

Replaced door switch - it took less than 5 minutes - works perfectly Read more

• Fridge runs too long
• Noisy
• Freezer section too warm
• Fridge too warm

After reviewing the 'how to' video on AppliancePartsPros.com, I unplugged the refrigerator and removed the back cover to access the motor. I then unplugged the wiring and removed the bad motor. I cut the clip plug and wired it to the new motor, installed the fan blade from the old motor and re-installed the new motor. After connecting the clip plug and re-installing the back cover, I plugged the refrigerator in and checked the interior about 5 minutes after the repair. Everything has been... Read more

Removed the handle with two screws on the inside front and pulled out the custom wood panel. Pulled the compactor out from under cabinet. Tipped it over on back of unit, supporting it with a little foot stool. Unscrewed two lower screws at bottom of unit holding black trim panel (that held wood panel in place) and lower black rubber flap. Removed two screws on lower outside side of unit that held the foot pedal. Slid off black U shaped metal frame from top of compactor towards bottom. Slid on... Read more

Ordered Bake Element, Y04100019 (Whirlpool AP4283614) to replace a broken bake element on my 30-year old Jenn-Air Model S125 Downdraft Slide-in electric range. Received the element very quickly but it had been damaged in shipping. Called AppliancePartsPros to report this and they quickly shipped another element - very easy process. To install the element, I turned off the power to the range, put on rubber gloves (just in case) and removed the two sheet metal crews at the rear of the oven -... Read more

Ordered new Evaporator part and Drier from Appliance Pros. The part arrived earlier than expected and was properly packaged. I had both parts installed by a professional as they required a level of expertise above my capabilities. Works perfectly. Read more

This trash compactor is in our vacation home. We never use it and now we are selling the house. When I looked to replace it I was amazed at how expensive a new compactor would cost. I found the serial number on the current compact entered it and your web site came up. Your schematics were excellent and made the repair very easy! Read more

Replaced broken retainer and put the shelf back in place. Read more

I had to cut one bar for the small door shelf since they only come in one size. The bars pop in on plastic clips. Read more

Replaced motor, fan and lock-nut. My repair was on a built in Refrigerator-Freezer so most of the time was spent on pulling out and putting back the unit to get to the area I needed to behind the upper top. Read more

Removed old. Installed new. Read more

I ordered and replaced the old ignitor and the corroded mounting screws. Read more

• Fridge too warm

Replaced the heater coil and the Thermostat underneath the freezer floor. 1. Unplug the Power, allow the ice build-up to thaw (Use hair-dryer). 2. Remove the heavy duty Plastic Tray (Freezer Floor) very carefully (the left and right side lips of the tray are snapped behind the sides of the freezer frame, un-snap the lips using flat spatula) . Gently pull out the Tray 3 Remove the plastic shroud (cold air diverter) at the back of freezer section (after removing the screw, tuck-up the shroud to... Read more

Replaced the heater coil and the Thermostat underneath the freezer floor. 1. Unplug the Power, allow the ice build-up to thaw (Use hair-dryer). 2. Remove the heavy duty Plastic Tray (Freezer Floor) very carefully (the left and right side lips of the tray are snapped behind the sides of the freezer frame, un-snap the lips using flat spatula) . Gently pull out the Tray 3 Remove the plastic shroud (cold air diverter) at the back of freezer section (after removing the screw, tuck-up the shroud to... Read more