Parts for Ge JGP331EM3: 02 - Section2 Parts

ST10-16 X 7/16"

Nickel

The Igniter Mounting Screw is an OEM replacement part for GE ovens and ranges. This screw secures the igniter to the burner assembly, ensuring it remains firmly in place for consistent and reliable ignition. Its precise fit and durable design help maintain the stability and functionality of the igniter.

Over time, mounting screws can become corroded, stripped, or lost during repairs or maintenance. A missing or damaged screw may result in a loose igniter, affecting the appliance's ability to ignite properly.

Symptoms of a bad or missing igniter mounting screw include:

• The igniter becoming loose or misaligned

• Difficulty securing the igniter during installation or repair
• The burner fails to ignite reliably or consistently
• Increased noise or movement of the igniter during operation

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

This replacement mounting screw secures panels and trim pieces on compatible appliances to restore proper fit and reduce rattling. Use it to replace missing or damaged screws that keep covers and components fastened. What it does:

• Fastens panels, trim, and small components to the appliance frame
• Restores secure attachment to stop vibration, noise, or loose panels
• Replaces missing, stripped, or corroded screws that prevent proper closure
• Works wherever the original screw type was used for mounting or securing parts

• Disconnect power to the appliance before servicing to avoid shock
• Use the correct screwdriver or bit to avoid stripping the head
• Start threading by hand to ensure proper engagement before tightening
• Do not over-tighten; snug until secure to avoid damaging threads or panels

This is a replacement mounting screw used to secure panels and components on compatible appliances. It restores proper fit and prevents rattling or loose parts for a safe, stable appliance. What it does:

• Secures panels, trim, brackets or small components in place
• Replaces missing or stripped fasteners that cause rattling or loose parts
• Helps maintain appliance alignment and safe operation when installed properly
• Small fastener for interior or exterior appliance assemblies

• Disconnect power (and gas if applicable) before servicing the appliance
• Use the correct screwdriver and hand-start threads to avoid cross-threading
• Do not overtighten; snug until secure to prevent stripping or damaging parts

This small replacement clip secures cabinet insulation in place to help maintain proper thermal performance and reduce vibration. A simple, original-equipment style retainer for restoring insulation fit and keeping internal components covered. What it does:

• Holds appliance insulation against the cabinet or inner panels
• Helps prevent insulation from sagging, shifting, or falling into vents or components
• Can reduce noise caused by loose insulation and help maintain temperature control
• Commonly needed when clips are broken, corroded, or missing

• One insulation retainer clip

• Disconnect power (and water if applicable) before accessing internal panels
• Remove access panels or liners to reach the insulation area; retain fasteners
• Push or snap the retainer into the designated hole/slot; some models may require light prying or a screwdriver for removal
• Wear gloves and eye protection to avoid cuts from sharp sheet metal and insulation fibers