Parts for Ge WSM2420SDZAA: 09 - Section9 Parts

This small, flat washer belongs in the lint filter assembly of the washer. It maintains proper spacing and helps seal the area so the filter stays secure and can capture lint as designed. What it does:

• Seats under the lint filter fastener/cap to ensure a secure fit
• Helps seal the lint filter area to reduce drips or seepage
• Keeps the lint filter properly positioned during wash and spin
• Common symptoms: water dripping at the lint filter, loose/rattling filter, increased lint carryover

• One lint filter washer

• Disconnect power and turn off water supply before servicing
• Access the lint filter per your model's instructions; remove the cap/fastener and old washer
• Clean mating surfaces; install the new washer and reassemble—do not overtighten
• Run a short fill/agitate test and check for leaks around the filter area

This tub ring gasket seals the washer tub to help prevent water leaks and keep the seal between the tub and cabinet tight. It restores the cabinet-to-tub interface for reliable water containment and cleaner operation. What it does:

• Forms a watertight seal at the tub opening to prevent leaks during fill and wash cycles
• Helps stop water from reaching the cabinet and surrounding floor
• Reduces the chance of mildew and odors by limiting water intrusion behind the tub
• Addresses symptoms such as visible water beneath the washer, drips from the front, or pooling around the base

• One tub ring gasket

• Disconnect power and water supply before beginning any repair
• Drain any remaining water from the washer tub to avoid spills
• Installation typically requires access to the front of the washer and may involve removing the front panel and/or door boot
• Wear gloves to protect hands from sharp edges and for a secure grip on the gasket