Parts for Lg DLE3470M: Section 2 Parts

The PCB Assembly, Main is an OEM part for LG dryers. Located inside the back panel, it controls all principal dryer functions including temperature, moisture levels, settings, and safety features. The main board receives temperature and motion sensor inputs to operate critical components like the heating element, motor, and fan. 

Causes of a bad main board may include liquid damage, failures due to long-term thermal cycling stresses, or manufacturing defects.

Symptoms of a bad PCB assembly include:

• Dryer not heating, tumbling, or stopping properly  
• Faulty moisture detection and settings  
• Repeated error codes
• Buzzing noises from internal mechanisms

This authentic LG replacement ensures dependable performance. Compatible with Sears/Kenmore dryers using LG mechanisms, it restores full functionality to maximize the dryer's lifespan. Proper operation preserves your investment.

If your dryer door pops open during cycles or won't stay closed, this door latch assembly restores a secure closure. Easy 5-minute DIY repair.

Replace missing or stripped taptite screws that secure panels and internal components. This thread-forming screw creates a tight hold to eliminate rattles.

This adjustable leveling leg screws into the dryer base to support and stabilize the cabinet. Replacing a worn or missing foot helps level the appliance, reduce vibration and noise, and keep it steady on uneven floors.

• Provides threaded height adjustment to properly level the dryer
• Stabilizes the cabinet to minimize rocking, vibration, and walking
• Replaces a broken, worn, or missing foot
• Common symptoms: dryer wobbles, is hard to level, or makes rattling/vibration noise

• Disconnect power; shut off gas supply for gas models
• With a helper, carefully tilt or raise the dryer for access
• Unscrew the old leg; thread the new leg into the base by hand, then adjust with a wrench until the dryer sits level and stable
• Ensure all legs contact the floor and the dryer does not rock

Hardware screws and nuts for installing a dryer side vent kit. Replace missing or stripped fasteners when reconfiguring exhaust outlet direction.

Stationary rack that installs inside your dryer drum to hold shoes, sweaters, and delicates that shouldn't tumble. Replace if cracked, broken, or missing.

This side venting kit allows you to redirect your dryer's exhaust air out through a side wall instead of the back of the unit. It includes the necessary ductwork and connections to safely route hot, moist air outside your home. Use this kit when your dryer installation requires side venting due to space constraints or structural limitations.