Parts for Lg DLEX7600VE: Section 2 Parts

Dryer door hinge connects the door to the cabinet frame. Replace if cracked, broken, or worn causing misalignment or door sagging. Installs with 3 screws.

Small trim cap that covers unused access holes on your dryer cabinet. Replace if cracked, broken, missing, or worn to protect internals and maintain a clean finish.

The Screw is an OEM part for LG dryers. This screw secures the front panel to the outer housing, ensuring a properly assembled unit.

Causes of a bad screw can include stripping of threads from over-tightening, loss of the screw from repeated access to internal components, or damage such as cracking from dropping or other impact.

Symptoms of a bad front panel screw include:

• Loose, detached, or missing front panel assembly
• Accessibility issues opening or closing the dryer door
• Reduced stability of the overall dryer cabinet structure

This OEM LG part is also compatible with some Kenmore models.

Precision mounting screw for dryers and laundry centers. Replaces missing, stripped, or damaged screws that secure panels, brackets, and assemblies. Restores stability.

Secures brackets, panels, and covers on your dryer. Replace missing, stripped, or damaged screws to keep components aligned and prevent rattling.

Secures the dryer door hinge to the cabinet frame. Replace this mounting bracket if it's cracked, broken, or worn to restore proper door alignment.

Dryer won't start or stops mid-cycle? This door strike hook secures the door latch, engaging the switch so cycles can begin and run properly.

Secures and aligns your dryer door for smooth opening and closing. Replace if door sags, misaligns, or doesn't seal properly. Verify fit with model.

Replace your dryer's worn, cracked, or broken door handle. Restores secure grip for opening and closing. Direct fit for original mounting points.

Replacement dryer door hinge that mounts the door to the cabinet frame. Needed when the original hinge is cracked, broken, or causes door misalignment.

This gasket creates an airtight seal between the dryer door and the drum opening to keep heated air inside the drum during operation. It is typically made of flexible felt or rubber and mounts around the door or the front of the tub. Replace this seal if you notice heat escaping around the door, longer drying times, or visible wear, tears, or hardening of the gasket material.

This adjustable leveling leg screws into the dryer base to support and stabilize the cabinet. Replacing a worn or missing foot helps level the appliance, reduce vibration and noise, and keep it steady on uneven floors.

• Provides threaded height adjustment to properly level the dryer
• Stabilizes the cabinet to minimize rocking, vibration, and walking
• Replaces a broken, worn, or missing foot
• Common symptoms: dryer wobbles, is hard to level, or makes rattling/vibration noise

• Disconnect power; shut off gas supply for gas models
• With a helper, carefully tilt or raise the dryer for access
• Unscrew the old leg; thread the new leg into the base by hand, then adjust with a wrench until the dryer sits level and stable
• Ensure all legs contact the floor and the dryer does not rock

Hardware screws and nuts for installing a dryer side vent kit. Replace missing or stripped fasteners when reconfiguring exhaust outlet direction.

This side venting kit allows you to redirect your dryer's exhaust air out through a side wall instead of the back of the unit. It includes the necessary ductwork and connections to safely route hot, moist air outside your home. Use this kit when your dryer installation requires side venting due to space constraints or structural limitations.