Parts for Ge JSP28GN2: 03 - Section3 Parts

A sturdy blower plate used to secure and align the dryer blower assembly, helping channel airflow for proper venting and heating performance. Restores correct blower positioning to reduce noise and improve air movement. What it does:

• Mounts and supports the blower wheel and motor assembly inside the dryer housing
• Directs airflow from the blower into the vent path for consistent drying
• Helps reduce rattling or scraping noises caused by a loose or misaligned blower
• Addresses poor drying or overheated cycles when blower alignment is compromised

• One blower plate

• Disconnect power before starting work to avoid shock risk
• Access may require removing the dryer front panel or cabinet per model service manual
• Inspect blower wheel and motor mount for wear when replacing this plate
• Tighten fasteners to OEM torque; reuse only manufacturer-recommended hardware

ST10-16 X 7/16"

Replacement fastener used to secure appliance components. If a screw is missing or damaged, panels and brackets can loosen or rattle. Installing a new screw restores a tight fit and helps keep parts properly aligned.

• Fastens panels, brackets, or internal components as designed for the model
• Replaces missing, stripped, or corroded hardware
• Helps reduce vibration/rattling and restores proper fit
• Maintains alignment and a secure assembly after service

• Disconnect power; shut off gas if applicable before servicing
• Support components while removing/installing fasteners
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening
• Replace all required screws in a location for even clamping and proper fit

This 8-32 thread screw fastens panels and components in compatible appliances, restoring secure mounting and stopping rattles or loose parts. Use it to replace stripped or missing fasteners and maintain proper alignment of covers and assemblies. What it does

• Secures panels, control boards, brackets, and accessory parts to the appliance chassis
• Restores proper fastening when original screws are missing, damaged, or stripped
• Helps eliminate vibration noise and loose-fit symptoms
• Matches common 8-32 appliance thread standards for a direct replacement

• One 8-32 thread screw

• Disconnect power to the appliance before beginning work to avoid shock or injury
• Use the correct-size Phillips or hex driver to prevent cam-out and head damage
• Install by hand first to engage threads, then tighten snugly—do not overtighten to avoid stripping

Nickel