Parts for Whirlpool LER3622DQ1: 03 - Section Parts

This white top panel replaces the outer cooktop surface on compatible ranges to restore a finished look and protect internal components from spills and debris. It's a direct-fit exterior part used when the original top is dented, cracked, or cosmetically worn. What it does:

• Covers and protects the range's internal components and burners from spills and heat exposure
• Restores a clean, finished appearance to the appliance exterior
• Helps maintain proper spacing and support for burner assemblies and controls
• Reduces risk of debris falling into the cabinet area below the cooktop

• One white top panel

• Requires basic disassembly of the cooktop; your model's service manual for step-by-step instructions
• Disconnect power (and gas supply if applicable) before beginning any repair to avoid shock or injury
• Use appropriate fasteners and gaskets from your model's parts list; do not force-fit parts

10 - 16 x 1/2

The Clip is an OEM part for Whirlpool dryers. This part secures the control knob to the dryer’s control panel, ensuring it remains firmly attached and functions correctly. The clip helps provide stability and precise control over the dryer settings.

Causes of a bad clip can include regular wear and tear, accidental damage during use, or stress from frequent adjustments.

Symptoms of a bad clip include:

• Knob becoming loose or falling off
• Difficulty turning the knob to adjust settings
• Knob not staying securely in place
• Knob wobbling or feeling unstable

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

This 3-cycle timer controls the sequence and duration of wash/dry cycles, restoring proper cycle advancement and timing for compatible appliances. Designed to replace a worn or non-advancing timer so your machine completes cycles as expected. What it does:

• Rotates through the machine's timed cycles to start, run, and end selected programs
• Opens and closes internal contacts to route power to motors, valves, or heaters at the right times
• Commonly replaces a timer that won't advance, stops mid-cycle, or fails to energize components
• Helps resolve symptoms like no cycle progression, no motor/heater activation, or stuck settings

• One 3-cycle timer

• Disconnect power before servicing to avoid shock risk
• Follow for removal, wiring locations, and mounting; label or photograph connections before disconnecting
• Handle the timer gently; avoid bending terminals or applying excessive force
• Test appliance functions after installation; some models may require timer indexing or calibration per OEM instructions

This is a replacement machine screw sized 8-18 x 3/8 that secures panels and components on compatible appliances. It restores proper fastening where a worn, stripped, or missing screw causes loose parts or rattling. What it does

• Fastens control panels, trim pieces, or brackets to the appliance chassis
• Replaces stripped, corroded, or missing screws that cause loose panels or vibrating noise
• Provides correct thread engagement for a secure hold in tapped holes
• Small hardware solution often used during door, console, or interior repairs

• One 8-18 x 3/8 machine screw (quantity: 1)

• Use the correct screw size and thread; do not force a different-size fastener into tapped holes
• Hand-start the screw to avoid cross-threading, then tighten with the appropriate screwdriver
• Disconnect power before accessing internal components or panels on electrical appliances
• If metal threads are damaged, repair with a helicoil or replace the damaged component rather than over-torquing

Color: White.

Color: White.

Specs: 10-16 x 1/2 inch.