Parts for Ge JGBP79WEV2WW: 04 - Section4 Parts

Positions and supports oven door glass to maintain proper alignment. Replace if worn, cracked, or missing to prevent glass rattling and gaps.

Replacement oven rack for electric and gas ranges. Installs inside oven cavity. Needed when original rack is missing, damaged, or warped from use.

Slotted grid that rests over the broiler pan to support food during broiling. Replace if cracked, warped, worn, or missing to restore proper function.

Replacement drawer panel that restores the front trim of your range drawer. Installs as the external front surface to replace a damaged, dented, or worn panel.

Includes 12 washers.

Hardware washer kit for various appliances. Includes 12 washers for securing components during installation or repair. Replace worn or missing washers.

White outer door glass panel for electric and gas ranges. Replaces cracked, broken, or chipped glass. Restores clean appearance and clear view into oven.

Door liner weld assembly for electric ranges. Replaces cracked, damaged, or broken door liner frames. Structural component that secures inner door panel.

Seals the gap between oven door and body to retain heat during cooking. Replace if cracked, worn, or heat escapes. Verify fit with your model number.

Mounting screw kit for ranges and ovens. Includes 12 screws for securing panels, brackets, or components. Replace missing or stripped screws.

Side insulation for range oven doors. Installs along the vertical edges inside the door assembly. Replace if torn, compressed, or missing for proper fit.

Insulation strip that installs along the bottom of your electric range door. Replace if torn, compressed, missing, or damaged to restore proper fit.

Oven door glass window pack for viewing food while cooking. Replaces cracked, shattered, or broken glass. Installs inside the oven door frame assembly.

Inner welded panel assembly for range control/backguard structure. Restores secure fit and alignment. Replace if bent, cracked, or damaged to stop rattling.

Replacement drawer glide for range bottom drawer. Needed when glide is broken, cracked, or snapped, causing drawer to fall, scrape floor, or not slide.

Secures the lower storage drawer assembly to your range cabinet. Replace this stamped metal bracket if cracked, bent, or missing to restore alignment.

Replacement terminal endcap for electric ranges. Covers exposed connector ends to restore a finished look and prevent accidental contact. Needed when cracked or missing.

Replace cracked, rusted, or chipped trim at the bottom of your range oven door. Installs with screws (sold separately) after removing the door.

Replace a cracked, warped, or missing heat deflector shield on your range. This protective guard installs near heating elements to direct heat properly.

This part has been discontinued and is no longer available.