Parts for Ge JSP62GN2: 04 - Section4 Parts

This left backguard end cap replaces a worn or damaged trim piece at the side of the range backguard, restoring a finished appearance and protecting the backguard edge from damage. Fits the left side of the backguard assembly. What it does

• Covers and finishes the exposed left edge of the stove backguard for a clean look
• Protects the backguard edge from chips, scrapes and everyday wear
• Helps keep wiring and internal components concealed at the backguard edge
• Commonly replaced when cracked, broken, warped or missing after impacts or age

• One left backguard end cap

• Disconnect power to the range before servicing to avoid electrical shock
• Access may require removing the backguard or control panel screws; retain fasteners for reassembly
• Align tabs/slots, then snap or secure the cap in place; replace any removed screws

If your range burner won't heat, stays on one temperature, or won't turn off, the infinite switch likely needs replacement. Moderate DIY repair.

Cooktop won't heat or stays on continuously? This infinite switch controls surface element temperature. Common fix for heating control issues on ranges.

Retainer secures glass panel in oven door. Replace if cracked, broken, or missing to properly hold door glass in place and restore door integrity.

Intermediate glass panel for oven doors. Installs between inner and outer door glass. Replace if cracked, shattered, or broken to restore appearance.

Seals and cushions the inner glass pane inside your oven door to contain heat and prevent rattling. Replace when cracked or flattened. Confirm fit.

This replacement refrigerator door gasket creates an airtight seal on the door to help maintain correct cooling and reduce frost buildup. Restores sealing performance to keep food colder and prevent moisture intrusion. What it does:

• Seals the door edge to maintain a cold interior and efficient operation
• Helps prevent warm air leaks that can cause temperature fluctuation
• Reduces frost and ice buildup in the fresh-food or freezer compartment
• Can improve cooling consistency and help avoid compressor overwork

• Disconnect power to the appliance before starting any repair.
• Remove food and any door-mounted items; support the door during gasket removal/installation.
• Replace the gasket by loosening/removing the door inner panel or pulling out the old gasket per OEM instructions; avoid sharp tools that might damage the door finish.
• After installation, check for even seating and close the door repeatedly to help the gasket form a proper seal; some gaskets may require gentle heating or a short break-in period per OEM guidance.

Package of 12 washers for ranges and ovens. Replaces missing, worn, or damaged washers used in various mounting and assembly points throughout your appliance.

Spacer bumper for electric ranges. Installs to provide proper spacing and cushioning between components. Replace if cracked, broken, or missing.

ST10-16 X 7/16"

Mounting screw for ranges and ovens. Secures panels, brackets, or internal components. Replace if stripped, missing, or damaged during repair work.

Package of 12

Secures the igniter to the burner assembly in gas ranges and ovens. Replace if stripped, missing, or damaged during igniter replacement or repair.