Parts for Lg WKGX301HBA: Section 4 Parts

This bolt assembly secures the appliance drum or tub to its mounting, restoring proper alignment and helping reduce noise, wobble and vibration caused by a loose or damaged fastener. What it does:

• Fastens the drum/tub to the suspension, shaft or mounting bracket to keep the assembly stable
• Replaces a worn, bent or broken bolt that can allow rubbing, knocking or excessive vibration
• Helps stop intermittent banging or misalignment caused by a loose or missing fastener
• Use only if the part matches your appliance's parts diagram and service manual

• Disconnect power (and water for washers) before beginning any repair
• Access and removal steps vary by model — follow the OEM service manual or exploded parts diagram
• Use correct tools and torque; do not overtighten or modify the bolt
• Inspect nearby mounts, bushings and suspension components for wear while replacing the bolt

Shipping bolt for laundry centers and washers. Secures the drum during transport. Replace if lost, damaged, or missing after installation or moving.

Shipping bolt for laundry center and washer installations. Secures internal components during transport. Replace if bolt is missing, stripped, or damaged.

Secures the outer door boot seal to prevent water leaks. Replace if damaged, rusted, or losing tension. Includes tensioning spring. Verify fit.

This drain hose cap seals and secures the refrigerator defrost drain outlet so meltwater is directed into the drain hose instead of pooling in the cabinet. Replaces a worn or damaged cap to help stop interior leaks and water buildup. What it does:

• Seals the defrost drain outlet to prevent water from spilling into drawers or onto shelves.
• Guides defrost/meltwater into the drain hose and toward the drain pan.
• Helps reduce odors and pests entering through an open drain opening.
• Fits onto the drain outlet to replace cracked, missing, or loose caps.

• Disconnect power before working inside the refrigerator to avoid electrical hazard.
• Remove shelves and drawers as needed to access the drain outlet; clear any visible debris or ice first.
• Press the cap firmly onto the drain outlet/hose until fully seated; avoid excessive force or prying tools.
• After installation, pour a small amount of warm water down the drain to confirm proper flow and seating.

Washer won't fill properly or overfills? The pressure switch monitors water levels and signals when to stop filling. Moderately easy DIY repair.

If your washer won't drain or leaks water during cycles, the drain hose assembly may need replacement. This hose carries water from the tub to your drain.

Washer won't start or shows dE/door lock error? This door switch detects if the door is closed so the cycle can begin. Easy DIY repair with video guide.