Parts for Ge DDE7200RALWW: 01 - Section1 Parts

This mini manual control is a small user-operated control used on compatible GE appliances to restore manual operation and basic control when an electronic actuator is unavailable or faulty. It provides a durable, serviceable interface for manual adjustments. What it does:

• Replaces a worn or broken manual control so you can operate the function by hand.
• Restores tactile control when the appliance does not respond to manual inputs.
• Helps stop slipping, intermittent engagement, or loose/damaged control feel.
• Used where a manual override or simple mechanical control is required.

• One mini manual control

• Disconnect power to the appliance before attempting service to avoid shock or injury.
• Remove access panels as needed to reach the control; refer to your model's service manual for panel removal steps.
• Inspect mounting hardware and wiring; replace any damaged fasteners or connectors.
• If electrical connections are present, verify proper reconnection and secure mounting before restoring power.

Installation and care guide manual for your dryer. Reference document for proper setup, maintenance instructions, and operating guidelines. Replace missing or damaged manuals.

Mounting plate for dryers. Secures internal components in place. Replace if cracked, bent, broken, or missing to restore proper structural support.

This part has been discontinued and is no longer available.

Ground clip secures electrical grounding wire in dryers. Replace if loose, corroded, or missing to ensure safe appliance operation. Confirm fit with model.

The Knob Clip is an OEM part for GE washing machines and dryers. This small but crucial component is designed to secure the control knob to the appliance's control panel.  

Over time, knob clips can wear out or break due to frequent use or accidental damage. When this happens, the control knob may become loose, fall off easily, or fail to engage the control panel properly, making it difficult to set the appliance to the desired cycle or function.

Symptoms of a bad Knob Clip include:

• The control knob is loose or falls off the panel easily.
• Difficulty in adjusting settings due to a loose knob.
• The knob does not stay in place or slips when turned.

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.

Dryer won't advance cycles or shuts off at wrong times? A faulty timer is usually the cause. This control restores proper cycle timing and progression.

Mounting screw for range installation and assembly. Replace missing, stripped, or damaged screws to secure panels, brackets, or components properly.