Parts for Frigidaire 72-7977-00-07: 02 - Splasher Control Parts

This part has been discontinued by the manufacturer and is no longer available.

Left-side support plate for upper oven cavity. Mounts inside range to provide structural stability. Replace if cracked, warped, or damaged during service.

Right-side support plate for upper oven cavity. Replace if cracked, bent, or missing to restore structural integrity and proper oven alignment.

This cable clip secures a refrigerator's wire harness or control cables, keeping wiring routed and protected to prevent pinching or contact with moving parts. A small but important retainer for safe, tidy internal wiring. What it does:

• Holds and routes wire harnesses or cables to prevent interference with drawers, doors, or moving components
• Reduces wear and chafing on wires by keeping them away from sharp edges and heat sources
• Helps maintain reliable electrical connections by preventing strain on harnesses
• Commonly replaced when clips are broken, cracked, or missing and wires become loose or misrouted

• Turn off power to the appliance before accessing internal wiring
• Install by snapping clip onto designated frame or mounting boss and seating wire(s) into the clip
• Replace any damaged wiring or connectors discovered during installation

Decorative bezel ring that fits around your range's burner control knob. Replace if cracked, discolored, or missing to restore a clean appearance.

This part has been discontinued by the manufacturer and is no longer available.

This upper burner retainer secures the surface burner head and helps keep the burner aligned for even flame distribution and reliable ignition. It's a small replacement part that restores proper burner positioning. What it does:

• Holds the upper surface burner head in place on gas cooktops and ranges
• Keeps the burner aligned so the flame and heat pattern are consistent
• Helps prevent burner wobble that can cause ignition issues or uneven cooking
• Compatible with original mounting points and hardware on compatible Frigidaire ranges

• One retainer — burner upper

• Disconnect gas supply and power to the appliance before working on burners; follow appliance manufacturer safety instructions
• Remove burner cap and head, replace the retainer, then reassemble in the original order
• Check burner alignment and ignition after reassembly; if you smell gas or see irregular flame, stop and inspect

Black hinge washer for electric and gas ranges. Replaces worn, cracked, or missing washers on door hinges to ensure proper door alignment and support.

Specs: 8 - 18 x 0.500

Secures the oven bottom panel in place. Replace if screw is stripped, missing, or no longer holds the panel securely. Sold individually.