Parts for Frigidaire 8468A: Splasher Page 2 Parts

This part has been discontinued by the manufacturer and is no longer available.

Right-side support plate for upper oven cavity. Replace if cracked, bent, or missing to restore structural integrity and proper oven alignment.

Left-side support plate for upper oven cavity. Mounts inside range to provide structural stability. Replace if cracked, warped, or damaged during service.

This cable clip secures a refrigerator's wire harness or control cables, keeping wiring routed and protected to prevent pinching or contact with moving parts. A small but important retainer for safe, tidy internal wiring. What it does:

• Holds and routes wire harnesses or cables to prevent interference with drawers, doors, or moving components
• Reduces wear and chafing on wires by keeping them away from sharp edges and heat sources
• Helps maintain reliable electrical connections by preventing strain on harnesses
• Commonly replaced when clips are broken, cracked, or missing and wires become loose or misrouted

• Turn off power to the appliance before accessing internal wiring
• Install by snapping clip onto designated frame or mounting boss and seating wire(s) into the clip
• Replace any damaged wiring or connectors discovered during installation

Decorative bezel ring that fits around your range's burner control knob. Replace if cracked, discolored, or missing to restore a clean appearance.

This part has been discontinued by the manufacturer and is no longer available.