Tappan Cable Or Retainer

The Door Spring Linkage is an OEM part for Frigidaire dishwashers. This part connects the door springs to the dishwasher door, ensuring smooth and balanced opening and closing of the door.

Causes of a bad door spring linkage can include wear and tear from frequent use, physical damage from impacts or mishandling, or deterioration over time.

Symptoms of a bad door spring linkage include:

• The dishwasher door not staying open or closed
• Difficulty in opening or closing the door
• A loose or sagging door
• Unusual noises when operating the door

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

This oven light lens retainer secures the glass light cover to the oven cavity so the bulb area stays protected during cooking. Replacing a damaged or missing retainer keeps the lens firmly in place and prevents nuisance loosening.

• Holds the glass light lens securely inside the oven cavity
• Helps shield the bulb area from splatters and debris
• Direct replacement for a bent, warped, or missing retainer ring
• Common symptoms: lens won't stay in, cover rattles, or difficulty securing the lens after service

• Disconnect power at the breaker and allow the oven to cool completely
• Remove oven racks for easier access to the light cover area
• Support the glass lens while positioning the retainer to avoid drops or chipping
• Secure the retainer per your model's design; do not overtighten

This upper burner retainer secures the surface burner head and helps keep the burner aligned for even flame distribution and reliable ignition. It's a small replacement part that restores proper burner positioning. What it does:

• Holds the upper surface burner head in place on gas cooktops and ranges
• Keeps the burner aligned so the flame and heat pattern are consistent
• Helps prevent burner wobble that can cause ignition issues or uneven cooking
• Compatible with original mounting points and hardware on compatible Frigidaire ranges

• One retainer — burner upper

• Disconnect gas supply and power to the appliance before working on burners; follow appliance manufacturer safety instructions
• Remove burner cap and head, replace the retainer, then reassemble in the original order
• Check burner alignment and ignition after reassembly; if you smell gas or see irregular flame, stop and inspect

This glass retainer wire secures the oven door glass so it stays in place during use, helping keep the door sealed and preventing rattling or a loose inner panel. It's a direct-fit replacement for the factory retainer. What it does:

• Holds the inner/outer oven door glass panels in the door frame to prevent movement
• Keeps the glass properly aligned to help maintain door sealing and stable operation
• Stops rattling or vibration caused by a loose glass panel
• Commonly replaced when the original retainer is bent, broken, or missing

• One glass retainer wire

• Disconnect power to the appliance before servicing and work only on a cool door
• Handle glass panels carefully to avoid breakage and injury; use gloves and eye protection
• You may need to remove the oven door or inner door panel to access the retainer; follow OEM instructions

This small replacement retainer secures the griddle igniter so the igniter stays correctly positioned for reliable spark and consistent lighting. It restores proper alignment to help the griddle burner light safely and evenly. What it does:

• Holds the griddle igniter in place so the igniter tip stays aligned with the burner for consistent sparking
• Prevents the igniter from shifting or touching adjacent parts that can cause misfiring or damage
• Common symptom fix: griddle burner fails to light or sparks but flame does not establish due to misaligned igniter
• Helps maintain safe burner operation by keeping the igniter stable during use

• One igniter retainer specific to griddle burner assemblies

• Disconnect electrical power and shut off gas supply before servicing gas components
• Handle ceramic igniters and the retainer carefully; avoid impact and avoid bending the igniter electrode
• Reinstall so the igniter tip is properly centered over the burner slot; do not overtighten fasteners