Tappan Housing Or Cover

Replace a cracked, broken, or missing outer housing cover on your range. This trim piece protects internal components and restores the finished look.

Control box housing for refrigerator electronic control boards. Replaces cracked, broken, or missing housings that protect the circuit board assembly.

Replacement cover for your electric range control panel. Restores appearance when the original is cracked, broken, or discolored from wear and heat exposure.

Replacement housing cover for your range. Installs on the exterior or internal housing assembly. Order a new cover if yours is cracked, broken, or missing.

Vent opening cover for gas ranges. Replaces cracked, broken, or missing covers that expose the vent area. Installs over the vent opening on the cooktop.

Replace your range's backguard shield if the rear wall panel is cracked, dented, or damaged. Protects the wall behind your cooktop and covers wiring.

Replace your cracked or broken range valve cover. This protective housing installs over the gas valve assembly to shield internal components from damage.

Rod end cover for gas ranges. Protects and conceals the rod end mechanism. Replace if cracked, broken, or missing to restore proper appearance and coverage.

Protective cover for the light switch rod end assembly. Replace if cracked, broken, or missing to shield the switch and maintain proper door light operation.

Replace your range's griddle cover if it's cracked, broken, or missing. This protective cover installs over the griddle surface on your cooktop.

Replace your gas range's burner control knob housing cover if cracked, broken, or missing. Installs on the control panel to protect internal components.

This rear wall shield protects the appliance's interior back panel from heat, moisture and component contact, helping keep internal parts secure and preventing damage. It's a simple replacement that restores proper protection behind the cabinet. What it does:

• Acts as a barrier between internal components and the cabinet rear to prevent wear or heat damage
• Helps direct airflow and keeps wiring/components clear of the rear wall
• Reduces risk of debris or moisture reaching sensitive parts
• Can resolve symptoms like visible damage or gaps at the back panel and rattling from loose rear insulation

• One rear wall shield

• Disconnect power (and gas, if applicable) before starting any repair
• Handle carefully; edges may be sharp—use gloves and eye protection
• Remove outer panels as needed to access and align the shield, then secure with existing fasteners

This cover is a molded trim piece that conceals and protects the appliance's internal components while restoring a finished appearance. It replaces a cracked, broken or missing cover to keep wiring and fasteners out of sight and reduce dust entry. What it does:

• Covers and protects control or component openings to prevent debris and accidental contact
• Restores cosmetic appearance when the original cover is cracked, warped or missing
• Helps maintain a proper fit of adjacent panels and trim
• Can eliminate rattling or vibration caused by a damaged cover

• One cover

• Disconnect power to the appliance before starting any repair to avoid shock or injury
• Basic hand tools typically required; remove surrounding trim or screws for access
• Align tabs and screw holes carefully—do not force the part into place
• If clips or mounting hardware are damaged, replace them before final installation

Replace your cracked or broken range control panel cover. This housing protects internal components and maintains the appearance of your cooktop or oven.