Tappan Dishwasher Clip Or Clamp

This thermostat retainer is the mounting clip that keeps the dishwasher's thermostat secured to its base or bracket. Proper retention helps maintain accurate temperature sensing and consistent heater safety through the wash and dry portions of the cycle. What it does:

• Holds the thermostat firmly in place on the base or mounting bracket
• Prevents the thermostat from shifting, vibrating loose, or falling out of position
• Supports accurate temperature sensing and overheat protection
• Common signs of a bad/missing retainer: broken or warped clip, thermostat hanging loose, intermittent heat/drying performance

• 1 thermostat retainer

• Disconnect power and shut off water before servicing
• Remove the lower access/toe-kick panel to reach the thermostat area
• Note the thermostat's orientation; transfer it to the new retainer and snap/secure the retainer to the existing mount/hardware
• Ensure the thermostat is fully seated and wiring is routed clear of sharp edges and hot/moving components

This sump retainer secures the appliance sump assembly and helps keep the pump seal and surrounding components properly positioned to reduce leaks and maintain correct water flow. It's a small replacement part used during sump or pump repairs. What it does:

• Holds the sump housing or pump assembly in place to maintain a reliable seal
• Helps prevent water leaks from the pump/sump area when installed correctly
• Keeps internal components aligned for proper water circulation and drainage
• Commonly replaced when sump hardware is cracked, warped, or no longer secures the pump

• One sump retainer

• Power off and unplug the appliance before starting any repair
• Verify you have full access to the sump/pump area; removal of panels or racks may be required
• Inspect surrounding seals and gaskets; replace if damaged to ensure a watertight fit

Red

This blower clamp secures the dryer/freezer/blower assembly so the fan stays aligned and stable during operation, helping reduce vibration and loud rubbing noises. It's a simple replacement that restores proper blower support. What it does:

• Fastens the blower housing or wheel securely to its mount to prevent wobble
• Keeps the blower aligned for consistent airflow and efficient operation
• Helps stop rubbing, scraping, or rattling noises caused by a loose blower
• Prevents wear to adjacent components caused by an unsecured blower

• Disconnect power before servicing and follow all safety guidelines for your appliance
• Remove the access panel and blower housing to reach the clamp; note orientation before removal
• Replace the clamp if bent, cracked, or missing and tighten so the blower is held firmly without binding
• Inspect surrounding seals, screws, and the blower wheel for damage while servicing