Tappan Range / Cooktop / Oven Parts

Oval-head square-drive screw secures interior and exterior oven panels, brackets, and trim. Replace worn, stripped, or missing screws for secure assembly.

Replace your range oven door seal to maintain proper heat retention and cooking efficiency. Prevents heat loss and improves energy use. Verify fit with your model.

The pressure regulator with bracket controls gas flow to the range burners and is typically located behind the range. Replace when burners won't light, flame is irregular, or you smell gas during operation.

Fix a range door that won't stay closed or latch properly with this door latch replacement. Simple repair restores secure door closure and operation.

Replace your cracked or broken range valve cover. This protective housing installs over the gas valve assembly to shield internal components from damage.

This main wiring harness connects a refrigerator's control board and key components, providing organized power and signal routing so controls, lights and the compressor operate reliably. Replaces a damaged or burned main harness for restored electrical continuity. What it does

• Routes power and signal connections between the control board, lights, compressor and sensors.
• Prevents intermittent operation caused by loose, corroded or broken wiring.
• Can stop failures such as no lights, components not running, or control errors when the harness is the fault.
• Keeps wires organized and secured to avoid chafing and shorting.

• One main wiring harness as pictured.

• Disconnect power before servicing to prevent shock or damage.
• Compare the new harness to the original and route wires the same way; replace any damaged clips or grommets.
• Reconnect all terminals fully; loose connectors can cause intermittent faults.

Fix a burner that won't light, stays on, or has uneven flames with this range top burner valve. Controls gas flow to restore proper burner operation.

Black right-side end cap for range control panels. Replaces cracked, broken, or missing endcaps that leave control panel edges exposed or unfinished.

A decorative black end panel that covers the left side edge of your range for a finished appearance. Located at the left end of the range when viewed from the front, it should be replaced when cracked, discolored, or damaged, affecting the appliance's appearance.

Replacement auto latch rod for your range door mechanism. This metal rod connects the latch assembly. Order a new one if yours is bent, broken, or missing.

Replace your range's clock knob if the original is cracked, broken, or missing. This control knob installs on the clock timer dial for proper time setting.