Tappan Range / Cooktop / Oven Parts

Mounting bracket for electric and gas ranges. Secures components in place. Replace if bent, cracked, or broken to restore proper fitment and stability.

White plastic spacer that mounts between the oven handle and door. Replace if cracked, broken, or missing to restore proper handle alignment and appearance.

Replaces the damaged, cracked, or missing inner floor panel that covers the oven cavity. Restores a clean appearance and protects components.

Endcap for electric ranges. Covers and protects the end of a trim or component. Replace if cracked, broken, or missing to restore appearance.

Indicator light bulb illuminates control panel displays on your range. Replace when light dims or burns out to restore visibility. Verify fit with model number.

Replace your worn or missing range spacer to restore proper component alignment and spacing. This small plastic part maintains correct clearances inside the unit.

Push-in plug button that covers openings in the oven bottom panel. Replace if cracked, missing, or broken to keep debris out and maintain a clean finish.

Anti-tip bracket secures your range to the wall or floor, preventing forward tipping. Replace if bracket is bent, broken, or missing during installation.

Replace your range door gasket rope seal to prevent heat loss and improve oven efficiency. Essential when seal shows wear, cracking, or gaps. Verify fit with your model number before ordering.

This is a starter receptacle socket used in the lighting circuit of a range or oven. It holds the fluorescent lamp starter in place and provides the electrical connection needed to ignite the oven light. Replace this receptacle if the oven light flickers, fails to turn on, or the socket shows signs of burn damage or corrosion.

Replace your range's lower selector knob if it's cracked, broken, or missing. This 6-position control knob installs on the front panel for adjusting settings.

Insulation shield for electric ranges. Installs to protect internal components from heat. Replace if cracked, damaged, or missing for proper insulation.

Replacement 10-24 x 5/8 screw for securing panels, brackets, and trim on ranges and ovens. Needed when original hardware is stripped, missing, or worn.

This cable clip secures a refrigerator's wire harness or control cables, keeping wiring routed and protected to prevent pinching or contact with moving parts. A small but important retainer for safe, tidy internal wiring. What it does:

• Holds and routes wire harnesses or cables to prevent interference with drawers, doors, or moving components
• Reduces wear and chafing on wires by keeping them away from sharp edges and heat sources
• Helps maintain reliable electrical connections by preventing strain on harnesses
• Commonly replaced when clips are broken, cracked, or missing and wires become loose or misrouted

• Turn off power to the appliance before accessing internal wiring
• Install by snapping clip onto designated frame or mounting boss and seating wire(s) into the clip
• Replace any damaged wiring or connectors discovered during installation