Thermador Range Hood Housing Or Cover

Protective cap that mounts over control switches on your range hood control panel. Replace if cracked, broken, or missing to keep switches properly aligned.

Keep your appliance's controls working reliably with this switch cover. It mounts over a switch to hold it in place and shield it from damage, helping ensure consistent actuation and long service life.

• Retains and protects a control/interlock switch within its housing
• Helps keep the switch aligned for reliable on/off detection
• Shields the switch from dust and incidental contact
• Cracked, loose, or missing cover can cause intermittent operation or no response when the control is pressed

• Disconnect power to the appliance before servicing
• Remove the necessary panel to access the switch; note wire positions/orientation
• Transfer any clips/screws from the old cover and seat the switch fully
• Secure wiring away from pinch points before reassembly

Replacement lamp support cover for range hood light housing. Shields bulb and wiring from grease and moisture. Replaces cracked, broken, or missing covers.

Protective boot that covers the capacitor terminal on your range hood. Replace if cracked, torn, or missing to shield connections from moisture and dirt.

This is a filter module designed for a range hood ventilation system. It captures grease, smoke, and airborne particles generated during cooking to keep the air clean and protect internal fan components. Replace this filter module if you notice reduced airflow, increased grease buildup on surrounding surfaces, or lingering cooking odors in the kitchen.

Nickel-plated dome plug cap for range hood housing. Replaces cracked, missing, or worn decorative plugs. Installs on ventilation cover assembly.

This is the front control panel for a range vent hood that houses the buttons or switches for fan speed, lighting, and other ventilation settings. It mounts to the underside or front face of the hood and provides the user interface for operating the exhaust system. Replace this panel if buttons are unresponsive, the panel is cracked or damaged, or if the controls no longer properly activate the fan or lights.

This left-side blower housing is the welded assembly that supports and directs airflow for the appliance's blower. It restores proper airflow routing and mechanical support for the blower motor and wheel. What it does

• Houses and secures the blower wheel and motor on the left side of the blower chamber
• Directs exhaust/intake airflow to maintain correct ventilation paths
• Helps prevent rubbing and vibration by holding blower components in alignment
• Addresses symptoms such as unusual air flow, rattling or contact noise, and reduced ventilation performance

• Recommended for this replacement: disconnect power and follow OEM service instructions before starting
• Handle carefully to avoid bending mounting tabs or damaging mating seals
• Use original fasteners and gaskets; replace any damaged mounting hardware