Parts for Maytag MED4100DW0: 02 - Top And Console Parts

Replaces the upper cabinet cover of your dryer. Needed when the original panel is dented, rusted, warped, or damaged. Restores a secure fit and clean look.

Outer housing that covers the dryer control area. Replaces cracked, discolored, or broken console shells. Protects internal controls and restores look.

Console mounting bracket for dryers. Secures the control panel to the cabinet. Replace if cracked, bent, or broken to restore proper console support.

A direct-replacement control panel assembly that restores the appliance's front user interface so you can select cycles and settings easily. Replaces a damaged, cracked, or unresponsive control surface to regain normal control operation. What it does

• Houses the touchpad/buttons and display area used to select oven/range functions and temperatures.
• Replaces worn, cracked, or unresponsive front controls that cause buttons or the display to fail.
• Can resolve issues with unresponsive key presses or missing/obscured display segments when paired with a working control board.
• Provides the visible user interface and mounting surface for control electronics.

• Disconnect power at the breaker or unplug the appliance before starting—electric shock risk.
• Remove trim or screws securing the old panel; handle glass or plastic fascia carefully to avoid breakage.
• Some models require transfer of clips, trim, or button pads from the old panel—keep small parts organized.
• After installation, restore power and test all buttons and display functions before reassembling remaining trim.

This control knob attaches to the appliance's control shaft so you can select settings with a solid, positive feel. Replace a cracked, stripped, or missing knob to restore smooth operation and a clean, finished look.

• Attaches to a switch or valve shaft to select temperatures, burner levels, or cycles
• Transfers your hand turn to the control shaft for accurate setting changes
• Common symptoms: cracked hub, spins without engaging, wobbly/loose, falls off, or missing
• Helps maintain a uniform appearance across the control panel

• Disconnect power (and shut off gas, if applicable) before servicing
• Pull the old knob straight off the shaft; avoid prying against the control panel
• Align the insert with the shaft's flats or splines and press straight on until fully seated
• Match position- and finish-specific knobs to the original on models that use different knobs per location

The Wire Harness is an OEM part for Whirlpool dryers. This wire harness is responsible for delivering power and electricity throughout the dryer and to its individual components. 

Causes of a bad wire harness can include fraying or exposed wires due to wear and tear over time, cracking or damage of protective casings that expose internal wirings, or malfunctioning connections that disrupt power flow.

Symptoms of a bad wire harness include:

• The dryer not starting or powering on
• Components like the drum or heating elements not working
• Buzzing or humming noises coming from inside the dryer
• Tripped or blown fuses
• Error codes or failure to progress through cycles properly

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.